Audio Adjustments; Introduction Of Audio Adjustments; Compensating For Equalizer Curves (Eq Ex) - Pioneer DEH-P5500MP Operation Manual

Section

Audio Adjustments

08
Introduction of audio
adjustments
1 2
6 5
1 SFEQ indicator
Appears in the display when SFEQ function
can be activated.
2 Loudness indicator
Appears in the display when loudness is
turned on.
3 SW indicator
Shows when the subwoofer output is turned
on.
4 Audio display
Shows the audio adjustments status.
5 EQ-EX indicator
Appears in the display when EQ EX function
can be activated.
6 CUSTOM indicator
Shows when custom equalizer curve is pre
sently selected.
% Press AUDIO to display the audio func-
tion names.
Press AUDIO repeatedly to switch between
the following audio functions:
FAD (balance adjustment)EQ (equalizer
curve adjustment)B (bass and treble level
adjustment)LOUD (loudness)SUB, W
(subwoofer on/off setting)/NOFAD (non fading
output on/off setting)80: 0 (subwoofer set
ting)/NOFAD (non fading output setting)
32
En
HHHHHHHHHHHHHH
3
4
HPF (high pass filter)SLA (source level ad
justment)
# If EQ EX function has been selected and only
when EQ EX is turned on and CUSTOM is se
lected as the equalizer curve, you can switch to
B.
# When the subwoofer controller setting is only
P/O :FUL, you cannot switch to SUB, W. (Refer to
page 40.)
# You can select the 80: 0 only when subwoofer
output is turned on in the SUB, W.
# When the subwoofer controller setting is only
P/O :FUL, you can switch to the non fading out
put on/off setting. (Refer to page 40.)
# You can select the non fading output setting
only when non fading output is turned on in the
non fading output on/off setting.
# When selecting the FM tuner as the source,
you cannot switch to SLA.
# To return to the display of each source, press
BAND.
Note
If you do not operate the audio function within
about 30 seconds, the display is automatically re
turned to the source display.
Compensating for
equalizer curves (EQ-EX)
The EQ EX compensates for each equalizer
curve. Furthermore, you can adjust bass and
treble for each source when CUSTOM curve is
selected.
! If SFEQ has been previously selected, press
EQ-EX and hold to switch to EQ EX and
EQ-EX appears in the display.
% Press EQ-EX to turn EQ-EX on.
EQ-EX:ON appears in the display. EQ EX is
now on.
# To turn EQ EX off, press EQ-EX.