Table of Contents
Advertisement
8.5.2
Reminder
When you set a reminder for a particular programme, the
receiver sends a warning at the start of that programme and
switches automatically to the right channel if you accept the
reminder message.
Select the Reminder item from the Timer sub-menu to
access the Reminder screen.
To activate a reminder:
- Set the values of the reminder parameters using the arrow
keys or numerical keys as indicated in the above paragraph.
- Press <OK> to confirm.
Note: an existing reminder can be disabled by selecting Disable as
Timer Type in the Reminder screen. When a timer is already
active (recording in progress), press <TIMER> then <0> to
cancel this timer.
8.5.3
Sleep timer
You can set a sleep timer to automatically switch your
receiver to Standby mode after a given time lapse.
Select the Sleep item from the Timer sub-menu to access
the Sleep screen.
To activate a sleep timer:
- Select the time lapse after which the receiver should go to
Standby (up to 4:59) using the
increase the time lapse steps of 10 minutes or using the
numerical keys of the remote control.
- Press <OK> to confirm.
To disable a sleep timer:
- Select Disable instead of a time lapse for this timer.
- Press <OK> to confirm.
8.6
System setting
Select System Setting from the main menu to access
the System Setting screen.
This screen is used to modify the general settings of your
receiver and your remote control setting.
Note: access to this menu can be protected by Pin Code.
To open the Installation sub-menu, you must enter
your PIN code.
or
key to decrease or
u
i
MENU 27
Advertisement
Table of Contents
