Enabling And Disabling Management Egress Interface Selection - Dell S4048T Configuration Manual

Application Name
NTP
DNS
FTP
Syslog
Telnet
TFTP
Radius
Tacacs
HTTP
If you configure a source interface is for any EIS management application, EIS might not coexist with that
interface and the behavior is undefined in such a case. You can configure the source interface for the
following applications: FTP, ICMP (ping and traceroute utilities), NTP, RADIUS, TACACS, Telnet, TFTP, syslog,
and SNMP traps. Out of these applications, EIS can coexist with only syslog and SNMP traps because these
applications do not require a response after a packet is sent.
The switch also processes user-specified port numbers for applications such as RADIUS, TACACS, SSH, and
sFlow. The OS maintains a list of configured management applications and their port numbers. You can
configure two default routes, one configured on the management port and the other on the front-end port.
Two tables, namely, Egress Interface Selection routing table and default routing table, are maintained. In the
preceding table, the columns Client and Server indicate that the applications can act as both a client and a
server within the switch. The Management Egress Interface Selection table contains all management routes
(connected, static and default route). The default routing table contains all management routes (connected,
static and default route) and all front-end port routes.
Enabling and Disabling Management Egress
Interface Selection
You can enable or disable egress-interface-selection using the management egress-interface-
selection command.
Port Number
123
53
20/21
514
23
69
1812,1813
49
80 for httpd
443 for secure httpd
8008 HTTP server port for confd
application
8888 secure HTTP server port for confd
application
Client
Supported
Supported
Supported
Supported
Supported
Supported
Supported
Supported
Internet Group Management Protocol (IGMP)
Server
Supported
Supported
Supported
442