Haier HBF600T Service Manual page 21

Front Load Washer Model:HBF600T
4).Brackets are available for drainage pipe arrangement.
Note: The water outlet should not be submerged in water.
2.Filling hose
1).Connect one end of the filling hose to the faucet and the other to the water electromagnetic valve of
the washer.
2).If the pipe of tap water is new or has not been used for a long time, turn on the faucet until the water
is clean.
3).Do not disconnect the filling hose frequently after it is joined with the faucet. Open the faucet before
operation to check if the faucet joint leaks to prevent accident.
Unpack and installation
3.Earth lead
1).The washer should be properly earthed during operation.
2).If the socket has earth wire, no auxiliary earth wire is needed.
3).If the socket has no earth wire, connect the auxiliary earth wire to the auxiliary earth terminal at upper
left on the back of the washer and then earth the wire correctly.
Note: It is strictly prohibited to connect the earth wire to the tap
water pipes or heating pipes.
Cleaning and maintenance
Cleaning and maintenance
Cleaning
Please clean the inner tub regularly to keep it clean. The steps are as follows:
1).Shut off the power supply before cleaning.
2).To clean the detergent dispenser, draw it out (see the left figure) and clean it with water.
3).To wash the body and rubber components, use a wet cloth with a little soapy water.
Attention: Never use gasoline or other solvent for cleaning.
When not in use
If the washer is not to be used for a long time,unplug it and turn off the faucet. Keep the door open to
prevent odors. It's recommended that the door is opened slightly when the washer is not being used.
Transportation
For transportation, assemble the fastening bolts as specified below so as to protect the inner components
from being vibrated.
20