Play From Radio; Play Audio From Tv Or Other Devices; Create Mp3 Audio Fi Les - Philips HTS3511E User Manual

Play from radio

The home theater can store up to 40 radio stations.
1
Check that the FM antenna is connected.
2
Press RADIO .
» " AUTO INSTALL...PRESS PLAY ' appears
on the display panel if you have not
installed any radio stations. Press
3
Press the following buttons to control play:
Button Action
/ Selects a preset radio station.
/ Searches for a radio station.
Fine tunes a radio frequency.
Press and hold to erase the
preset radio station.
Press to stop the installation of
radio stations.
PROGRAM Manual: Press once to access
program mode, and press again
to store the radio station.
Automatic: Press and hold for fi ve
seconds to reinstall radio stations.
Note
•
AM and digital radio are not supported.
•
If no stereo signal is detected, you are
prompted to install the radio stations again.
•
For the best reception, place the antenna away
from the TV or other sources of radiation.
Change tuning grid
In some countries, you can switch the FM tuning
grid between 50 kHz and 100 kHz. Changing
tuning grid erases all preset radio stations.
1
Press RADIO .
2
Press .
3
Press and hold
or 'GRID 10' (100 kHz) is displayed.
Play audio from TV or other
devices
Press AUDIO SOURCE repeatedly to select the
audio output of the connected device (see 'Connect
audio from TV or other devices' on page 9 ) .
.
until 'GRID 9' (50 kHz)
Create MP3 audio fi les
Use the home theater to convert audio CDs into
MP3 audio fi les.
1
Insert an audio CD (CDDA/HDCD) into
the home theater.
2
Connect a USB storage device to the home
theater.
3
When audio is played, press CREATE MP3 .
4
Select [Yes] and press OK to confi rm.
CREATE MP3
OPTIONS
Speed Normal
Bitrate 128kbps
CRT ID3 Yes
Device USB1
SUMMARY
Select Track 0
Time 00:00
Start Exit
5
Select the settings in the [OPTIONS] panel,
then press OK .
•
[Speed] : Selects the write-to-fi le speed.
• [Bitrate] : Selects the conversion quality.
• [CRT ID3] : Copies information on the
tracks in the MP3 fi les.
• [Device] : Selects the USB device
which you use to store the MP3 fi les.
6
to access the [TRACK] panel.
Press
7
Select an audio track, then press OK .
• [Select All] : Selects all tracks.
•
[ Deselect all ] : De-selects all tracks.
8
Select [Start] in the menu to convert, then
press OK .
» A new folder is created in the USB storage
device to store all the new MP3 audio fi les.
• To exit the menu, select [Exit] and
press OK .
Note
•
During the conversion process, do not press
any buttons.
•
DTS CDs and copy-protected CDs cannot be
converted.
•
Write-protected or password-protected USB
storage device cannot be used to store MP3 fi les.
TRACK
Track01 04:14
Track02 04:17
Track03 03:58
Track04 04:51
Track05 03:53
Track06 04:09
Track07 04:38
Select All Deselect All
EN 13