Scan Mode Image - Sony lmd-b170 Operating Instructions Manual

[Aperture]
Press the button to display the adjustment screen and
sharpen the picture outline. Press again to hide the
adjustment screen. However, the picture sharpness
remains adjustable. Turn the menu selection control
right to make the picture sharper, or left to make the
picture softer.
[Volume]
Press the button to display the adjustment screen and
adjust the volume. Press again to hide the adjustment
screen. However, the volume remains adjustable. Turn
the menu selection control right to increase the volume,
or left to decrease it.

Scan mode image

480i, 575i, 480p, 576p
Vertical pixels are set to
1080. Horizontal pixels
are displayed with scaling
to the appropriate aspect
ratio.
When an NTSC or PAL
signal is input, the screen
may appear small
depending on the signal.
480i, 575i, 480p, 576p
Displays the original
video signal pixels. If a
format other than 640 ×
480p is input, the screen
will not be displayed in
the appropriate aspect
ratio.
1080i, 1080PsF, 1080p,
720p
Horizontal pixels are set
to 1920 and vertical pixels
are displayed with scaling
to the appropriate aspect
ratio.
When an NTSC or PAL
signal is input, the screen
may appear small
depending on the signal.
1080i, 1080PsF, 1080p
720p
[Marker Setting]
Submenu Setting
[Marker] Selects [On] to display the marker and
[Off] not to display.
[Aspect Marker] Selects the aspect ratio of the aspect
marker. You can select between [4:3]
and [Off].
[Center Marker] Sets to [On] for displaying the marker
which represents the center of the
picture. Sets to [Off] for not displaying.
[Area Marker] Selects the safe area size for the aspect
marker. When the aspect marker is set
to [Off], this menu selects the safe area
size for the effective screen area. You
can select from among [Off], [80%],
[85%], [88%], [90%], [93%], [95%].
[Marker Intensity] Sets the luminance to display the
[Aspect Marker], [Center Marker], and
[Area Marker]. You can select between
[High] and [Low].
[Time Code Setting]
Submenu Setting
[Time Code] Selects [On] to display the time code
and [Off] not to display.
[Format] Sets the time code format.
[VITC]: To display the time code in

[LTC]: To display the time code in

[Position] Sets the position of the time code
display. You can select between [Top]
and [Bottom].
VITC format.
LTC format.
Adjustment Using the Menus
21