Firmware Version - Panasonic UF-9000 Service Manual

3.5.8. Firmware Emergency Recovery
The easiest method to recover the firmware in an Emergency Recovery routine is to either use the Local
Firmware Update Tool software by selecting the Independent File method, or using the Master Firmware
Flash Card method (3 Flash Cards required).
Whichever method you select, it is easier to restore the machine's firmware to the Standard (AAV) Type
first as it only requires 3 files to bring the machine to initial working condition. (Install the files in this
order: SC and SPC).
After recovering, if optional PCL or PS/PCL firmware is required, use the Network Firmware Update Tool
or the Local Firmware Update Tool to update the firmware to the required level.
If the unit does not boot up properly, follow the steps below:
1. Turn the power Off.
Before proceeding to the next step, you must prepare either the Local Firmware Update Tool or
create the Master Firmware Flash Cards (read the appropriate sections first).
2. Turn the power On while holding the [ENERGY SAVER] button.
3. When the green lamp on the front panel turns On, release the [ENERGY SAVER] button.
The unit is now ready to accept the firmware code from Master Firmware Card.
Repeat the above steps if there are additional firmware code files to be updated.
3.5.9.

Firmware Version

SC :
Ver. 1.0
DX-TRI A A Vxxxxx (a) AU
DP-TRI A A Vxxxxx (a) AU
Destination Code (Fax)
AU : USA/Canada
AB : UK
Destination Code (Copier)
PU : USA/Canada
PB : UK
Division Soft
(When it is divided into (a) and (b))
Firmware Version (V1xxxx)
Language Code
A : A-English, C-French & Spanish
B : A-English, Spanish & Portuguese
b : English, French & Spanish
g : German, French & Italian
etc.
Firmware Type
A : Standard
B, C, D, E : Optional
Model Number
81
UF-9000
DP-180/190
JAN 2004