Service Hints - Sanyo Vizzon HT27547 Service Manual

POWER FAILURE DETECTOR
This unit is equipped with a Power Failure Detector function
included in the CPU which checks for an abnormal condi-
tion in the chassis power supplies, including the power
supply derived from the Horizontal Output Transformer.
If, while the power is on, a failure is caused by any of the
following that results in a low voltage supply, the CPU will
turn the unit off in 1.5 seconds to prevent further damage:
•
Failure within the power supply circuits.
•
A short circuit in the load side from the supply.
•
Stoppage of the Horizontal Output Oscillator caused by
the X-Radiation protection Hold-Down Circuit.
If, while the power is off, the power is switched on and any
of these failures remains uncorrected, the CPU will shut off
the power within three seconds.
Video
IC801 (UOC)
30
29

SERVICE HINTS

Power Fail
Power ON/OFF
Check the following if the unit is turned off by the power
failure detector.
1. Disconnect the AC power cord (120V AC line) for at least
10 seconds.
2. Connect a DC Voltmeter to the circuits shown below.
3. Press the Power key and check for the proper voltage
supplies.
4. If any of these voltages is low, the power failure detec-
tor should turn the unit off within three seconds.
5. Check all circuits shown below.
Note: This unit is equipped with a Power Surge Protection
feature included in the CPU. If power failure occurs
three times within 15 minutes, the CPU will stop
functioning automatically to help prevent secondary
damage. (TV will not turn on by pressing the power
key.) To reset the operating programs within the CPU,
disconnect the AC power cord for at least 10 seconds.
Main
D509
D429
Q681
D654
Q682
D643
Q683
D801
PIN11
K5DMB
P/F ACK
— 13 —
TJ4 VERT
VCC
D428
Hold
Down
Circuit
D659
IC652
3.3VDM
Q641
14VTV
IC490
15VTV
DM