Page 3
If you have any questions about your tool please call: CHUCK 1-800-9-BD TOOL TRIGGER (1-800-923-8665) SWITCH LOCKING BUTTON 220 VOLT PLUG SIDE HANDLE 1180-220 (3/8") VSR HOLGUN DRILL CHUCK REVERSING LEVER TRIGGER SWITCH LOCKING 220 VOLT PLUG BUTTON...
154566/1180-220 5/17/02 1:32 PM Page 1 • KEEP CHILDREN AWAY. Do not let visitors contact tool or extension cord. FOR YOUR SAFETY - ALL TOOLS All visitors should be kept away from work area. • STORE IDLE TOOLS. When not in use, tools should be stored in dry, and WARNING: When using electric tools, basic safety precautions should high or locked-up place —...
154566/1180-220 5/17/02 1:32 PM Page 2 TOOL OPERATION the current your product will draw. An undersized cord will cause a drop in line voltage resulting in loss of power and overheating. The following table shows the correct size to use depending on cord length and nameplate...
154566/1180-220 5/17/02 1:32 PM Page 3 The reversing lever is used to reverse the drill for backing out screws or jammed bits. It is located above the trigger, shown in Figure 2. To reverse the drill, turn it OFF and push the reversing lever to the left (when viewed from the chuck end).
154566/1180-220 5/17/02 1:32 PM Page 4 6. IF DRILL STALLS, it is usually because it is being overloaded. RELEASE Figure 6 Figure 7 TRIGGER IMMEDIATELY, remove drill bit from work, and determine cause of stalling. DO NOT CLICK TRIGGER OFF AND ON IN AN ATTEMPT TO START A STALLED DRILL –...
154566/1180-220 5/17/02 1:32 PM Page 5 MAINTENANCE Every B&D tool is of the highest quality. If you wish to contact us regarding this product, please call toll Lubrication free between 8:00am and 8:00pm ET, seven days a week: All ball and sleeve bearings used are factory lubricated to last the life of the 1-800-9-BD TOOL bearings.