Atdpl: Assignment Of Toll Code Restriction Data For Ldm - NEC NEAX 7400 IMX Command Manual

ATDPL: Assignment of Toll Code Restriction Data for LDM

1. General
This command is used to assign the area code of Toll Restriction - 3/6 digits for an outgoing connection. This
data is written in Local Data Memory (LDM). When using common Toll Code Restriction data in Netfusing
Network, assign this data via ATDPN command.
2. Precautions
1. This command is used when restriction data is assigned to RES=2 (Toll Restriction is required) in the AR-
SCL command or in the ARRCL command.
2. The office code following the area code assigned on this command can also be specified by AARPL
(LDM)/AARPN (NDM) command.
3. Setting Method of Area and Office Code Restriction
TRK
ACC
CODE
9 –
In case the number to be dialed is as shown above.
(a) 3-Digit Toll Restriction
9 - 1 - NPA - Nxx - xxxx
A 3-digit toll restriction is a restriction that is to be executed by developing the contents (NPA in this
case) of the digits that follow the toll code.
If the data is set as follows, a toll call can be restricted by developing NPA.
• At Toll Code Restriction Data for LDM (ATDPL)
DC="9-1", TDI=2, NND=3 ("NPA")
• At Area & Office Code Data (AARPL)
DC="NPA" (Only 3 digits)
(b) 6-Digit Toll Restriction
9 - 1 - NPA - Nxx - xxxx
A 6-digit toll restriction is a restriction that is to be executed by developing the contents ("NPA" - Nxx
in this case) of the 6 digits that follow the toll code.
If data are set as follows, a toll call can be restricted by developing "NAP - Nxx".
• At Toll Code Restriction Data for LDM (ATDPL)
DC="9-1", TDI=2, NND=6 (NPA - Nxx)
• At Area & Office Code Data (AARPL)
DC="NAP - Nxx" (6 digits)
4. Data can be entered on a Day/Night basis, if specified in ASYD command, SYS 1, INDEX 75, Bit 3=1.
TOLL AREA
CODE CODE
1 – NPA
OFFICE STATION
CODE NUMBER
– Nxx – xxxx
ND-70348 (E)
ATDPL
CHAPTER 4
Page 300
Revision 3.0