Picture Tube Removal - Sony KV-XF29K94 Service Manual

2-12. PICTURE TUBE REMOVAL

!¡
!™ Demagnetic coil
0 Four claws
1 Four screws
(washer head)
7 C board
(+P 4 × 16)
8 Neck assy
9 Deflection
yoke
!¢ Two screws
(Tapping)
2 Speaker Bracket
assy (L)
5 Anode cap
!∞ Picture tube
Four DGC clip
!¶
DGC holder
6 Chassis assy
!§
Cushion
(50 × 550)
DGC
!£ Tension
spring
!¢ Two screws
(Tapping)
3 Four screws
(washer head)
(+P 4 × 16)
4 Speaker Bracket
assy (R)
Cushion
•REMOVAL OF ANODE-CAP
NOTE : After removing the anode, short circuit the anode of the picture tube and
the anode cap to the metal chassis, CRT shield or carbon paint on the
CRT.
•REMOVING PROCEDURES
a
a
1 Turn up one side of the rubber cap in the direction indicated by the arrow a.
b
2 Using a thumb pull up the rubber cap firmly in the direction indicated by the arrow b.
3 When one side of the rubber cap is separated from the anode button, the anode-cap
can be removed by turning up the rubber cap and pulling it up in the direction of the
arrow c.
•
HOW TO HANDLE AN ANODE-CAP
1 Do not damage the surface of anode-caps with sharp shaped objects.
2 Do not press the rubber too hard so as not to damage the inside of anode-cap.
A metal fitting called the shatter-hook terminal is built into the rubber.
3 Do not turn the foot of rubber over too hard.
The shatter-hook terminal will stick out or damage the rubber.
b
c
Anode button