Front Panel Layout Power/Access LED Mode Button/LED Red - USB mode Green - LAN mode Note: The DriveStation FlexNet can be connected to a computer as both an Ethernet NAS and a USB external hard drive at the same time. To switch between the two modes, press the mode button.
Back Panel Layout Power button Reset button Ethernet (to router) USB (to PC) Power...
Page 4
Installing Your DriveStation Insert the installation CD into your PC’s CD- ROM drive. Setup will automatically launch. Click Begin Installation. Click Install. The wizard will guide you through installation. First, you’ll install the DriveStation FlexNet as a USB device. Then, you’ll switch modes and install the DriveStation FlexNet in LAN mode as a NAS device.
Page 5
When installation is complete, you may close the installation window. Congratulations! Your DriveStation is ready to use. Turn to page 6 for instructions on DriveStation as a networked LAN drive, or page 7 for instructions on using it as a USB drive. User Manual Please see the on your DriveStation CD for more help...
Page 6
Using your DriveStation in LAN Mode In LAN mode, the mode button will glow green. If it’s red, press it. The LED will change to green. To use the DriveStation in LAN mode, it should be connected to a router on your network via an Ethernet cable.
It can be accessed from My Computer. By default, it will receive the next available drive letter and will be named HD-CELU2. FCC Warning This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.