Specifications; Specific Safety Rules - Makita 6310 Instruction Manual

ENGLISH
1-1. Low
1-2. High
1-3. Speed control screw
1-4. Switch trigger
1-5. Lock button
2-1. Reversing switch lever

SPECIFICATIONS

Capacities
No load speed (min
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Note: Specifications may differ from country to country.
Intended use
The tool is intended for drilling in wood, metal and
plastic.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated in accordance with European
Standard and can, therefore, also be used from sockets
without earth wire.
For European countries only
Noise
The typical A-weighted noise level determined according
to EN60745-2-1:
Sound pressure level (L
Uncertainty (K) : 3 dB(A)
The noise level under working may exceed 85 dB (A).
Wear ear protection.
Vibration
The vibration total
determined according to EN60745-2-1:
Work mode: Drilling into metal
Vibration emission (a
Model; 6310
EC-DECLARATION OF CONFORMITY
We declare under our sole responsibility that this
product is in compliance with the following standards of
standardized documents;
EN60745, EN55014, EN61000 in accordance with
Council Directives, 89/336/EEC, 98/37/EC.
Yasuhiko Kanzaki CE2005
Explanation of general view
3-1. Speed change knob
3-2. 0 - 2000 min
3-3. 0 - 700 min
3-4. Arrow
4-1. Side grip
5-1. Tighten
Model
Steel
Wood
-1
)
Overall length
Net weight
Safety class
) : 80 dB(A)
pA
value (tri-axial vector
2
) : 2.5 m/s or less
h,D
-1
-1
Hi: 8 mm
Hi: 20 mm
Hi: 0 - 2000
ENE032-1
000087
ENF002-1
MAKITA INTERNATIONAL EUROPE LTD.
Michigan Drive, Tongwell, Milton Keynes, Bucks MK15
8JD, ENGLAND
Responsible manufacturer:
Makita Corporation Anjo Aichi Japan

SPECIFIC SAFETY RULES

ENG101-1
DO NOT let comfort or familiarity with product
(gained from repeated use) replace strict adherence
to drill safety rules. If you use this power tool
unsafely or incorrectly, you can suffer serious
personal injury.
1. Use auxiliary handles supplied with the tool.
Loss of control can cause personal injury.
2. Hold power tools by insulated gripping
ENG202-1
surfaces when performing an operation where
the cutting tool may contact hidden wiring or
sum)
its own cord. Contact with a "live" wire will make
exposed metal parts of the tool "live" and shock
the operator.
3. Always be sure you have a firm footing.
ENH101-5
Be sure no one is below when using the tool in
high locations.
4. Hold the tool firmly.
5. Keep hands away from rotating parts.
6. Do not leave the tool running. Operate the tool
only when hand-held.
7. Do not touch the drill bit or the workpiece
immediately after operation; they may be
extremely hot and could burn your skin.
3
5-2. Chuck key
6-1. Tighten
6-2. Sleeve
6-3. Ring
7-1. Depth gauge
7-2. Screw
6310
Lo: 13 mm
Lo: 32 mm
Lo: 0 - 700
310 mm
2 kg
/II
Director
GEB001-2