Helpful Hints And Tips - Zanussi ZWC 1301 User Manual

Altering an option or a running
programme
It is possible to change any option before the
programme carries it out.
Before you make any change, you must pause
the washing machine by pressing the button
6
.
The programme can be changed as long as
6
the button has not been pressed. Chang-
ing a running programme is possible only by
resetting it. Turn the programme selector dial
to and then to the new programme posi-
tion. Start the new programme by pressing the
6
button again.
Interrupting a programme
6
Press the button
which is running, the corresponding light starts
to flash. Press the button again to restart the
programme.
Cancelling a programme
Turn the selector dial to
a programme which is running. Now you can
select a new programme.
Opening the door after the programme
has started
First set the machine to pause by pressing the
button Start.
After some minutes, the door can be opened,
when the following conditions are observed:
• The water temperature is below 55°C.
• The water level is below the bottom edge of
the door.

Helpful hints and tips

Sorting out the laundry
Follow the wash code symbols on each gar-
ment label and the manufacturer's washing in-
structions. Sort the laundry as follows: whites,
coloureds, synthetics, delicates, woollens.
10
to interrupt a programme
position to cancel
• The machine doesn't spin.
If you cannot open the door but it is absolutely
necessary to open it you have to switch the
machine off by turning the selector dial to
After few minutes the door can be opened
(Pay attention to the water level and
temperature !).
After this procedure, it will be necessary to set
the programme and the options again and
then press the button Start.
At the end of the programme
The machine stops automatically.
The pilot light End illuminates to indicate that
the programme has finished. The pilot light
Door goes out, the door can be opened and
the laundry can be removed.
If at the end of a programme there is water in
the tub (when "Rinse hold" option has been
selected), to empty out the water follow
the following instructions:
• turn the programme selector dial to
• select the «Drain» or «Spin» programme
• press button Start
When the pilot light Door goes out, the door
can be opened and the laundry can be re-
moved.
At the end of the cycle, turn the programme
selector dial to to switch the machine off.
Remove the laundry from the drum and care-
fully check that the drum is empty. If you do
not intend to carry out another wash, close the
water tap.
Leave the door open to prevent the formation
of mildew and unpleasant smells.
.
www.zanussi.com