Frame Lock - Panasonic TQBJ0323-1 Operating Instructions Manual

Menu operation (continued)
V FIT
Wide input signal*  projection without changing the
2
aspect ratio uses all the panel pixels in the vertical
direction to crop the right and left of the image.
Input signal: 1 080/60i
Image:
HV FIT
The image is projected all over the panel pixels
(screen). The input signal is projected at the aspect
ratio of the panel screen.
Input signal: 1 080/60i
Image:
S4:3
Standard input signal*  the input signal will be sized
1
down 75% and projected. S4:3 mode is effective when
projecting 4:3 image onto a 16:9 screen.
Input signal: XGA
Image: Panel:
* A standard signal has an aspect ratio of 4:3 or
1
5:4.
* A wide signal has an aspect ratio of 16:10, 16:9 or
2
15:9.
34  ENGLISH
Screen:
THROUGH
The image will be projected without any size
adjustment.
This function can be set when the input signal is smaller
than the number of the LCD panel pixels (1024 x 768).
Input signal: NTSC
Image: Panel:
NOTE:
• When a 4:3 image is projected to 16:9 screen, the image
may be distorted or some portions may be cropped. Select
an aspect ratio (4:3) which retains the creator's intended
image.
• The order of ASPECT types is defined not only by the input
method but also by the input signals.
• If you project an enlarged or distorted copyrighted image
using the ASPECT function for commercial use in a public
place, you might infringe the copyright of the creator which
is protected by the copyright law.
▌

FRAME LOCK

If the projected image is bad, you can activate FRAME
LOCK for synchronization. (For RGB input signal only)
Change
Change setting
setting
ON Active
OFF Deactive
Change
Change setting
setting