Important Information Regarding The Hdmi Connection; Ipod Messages - Pioneer VSX-820-K Operation Instructions Manual

Hide thumbs Also See for VSX-820-K:
Table of Contents

Advertisement

Available languages

Available languages

11
Additional information

Important information regarding the HDMI connection

There are cases where you may not be able to
route HDMI signals through this receiver (this
depends on the HDMI equipped component
you are connecting-check with the
manufacturer for HDMI compatibility
information).
If you aren't receiving HDMI signals properly
through this receiver (from your component),
please try the following configuration when
connecting up.
Configuration
Connect your HDMI-equipped component
directly to the display using an HDMI cable.
Then use the most convenient connection
(digital is recommended) for sending audio to
the receiver. See the operating instructions for
more on audio connections. Set the display
volume to minimum when using this
configuration.

iPod messages

Symptom
iPod/USB Error 1
(I/U ERR1)
iPod/USB Error 2
(I/U ERR2)
iPod/USB Error 3
(I/U ERR3)
No Track
76
En
Cause
There is a problem with the signal path
from the iPod to the receiver.
The software version being used with the
iPod needs to be updated.
An iPod not supported by this receiver is
connected.
When there is no response from the iPod. Update the iPod software to the latest
When there are no tracks in the category
selected on the iPod.
Note
• Depending on the component, audio
output may be limited to the number of
channels available from the connected
display unit (for example audio output is
reduced to 2 channels for a monitor with
stereo audio limitations).
• If you want to switch the input source,
you'll have to switch functions on both the
receiver and your display unit.
• Since the sound is muted on the display
when using the HDMI connection, you
must adjust the volume on the display
every time you switch input sources.
Action
Switch off the receiver and reconnect
the iPod to the receiver. If this doesn't
seem to work, try resetting your iPod.
Update the software being used with the
iPod (please use the latest iPod software
versions later than the iPod updater
2004-10-20).
Connect the iPod supported by this
receiver.
version. If this doesn't seem to work, try
resetting your iPod.
Select a different category.

Advertisement

Table of Contents
loading

Table of Contents