PERIODIC MAINTENANCE AND ADJUSTMENT
1. Turn signal light bulb
3. Insert a new bulb into the socket,
push it in, and then turn it clock-
wise until it stops.
4. Install the lens by installing the
screw. NOTICE: Do not over-
tighten the screw, otherwise the
lens may break.
7
Replacing the license plate
light bulb
1. Remove the license plate light unit
by removing the screws.
1. Screw
2. Remove the socket (together with
the bulb) by pulling it out.
[ECA11191]
1. License plate light bulb
2. License plate light unit
EAU24312
3. Remove the burnt-out bulb by pull-
4. Insert a new bulb into the socket.
5. Install the socket (together with the
6. Install the license plate light unit by
7-36
ing it out.
bulb) by pushing it in.
installing the screws.