AEG 37699MO-MN User Manual page 15

Oven side-guide rails (fig.8)
For an effective cleaning of the oven
side-guide rails, these can be extracted
unscrewing knurled nuts
To fit the rails back in their place, first
insert rear pins in holes and then secure
them with the knurled nuts
Oven seal
The oven seal guarantees the correct
functioning of the oven. We recommend
you:
• clean it, avoiding abrasive tools or
products.
• check its state now and then.
If the oven door seal has become hard
or is damaged, contact our Service
Centre and avoid using the oven until
it has been repaired.
Self-cleaning panels
Oven walls are protected by panels
coated with a grease-proof, microporous
enamel that absorbs and eliminates
splattering during baking.
If there is a lot of liquid or grease,
dry immediately with a damp sponge
and heat the oven for 2 hours on the
maximum thermostat position. Wait for
the oven to cool down and then go over
it again with a damp sponge. If you are
unable to remove all the substances,
repeat the above procedure.
It is, however, advisable to periodically
remove the panels and wash them with
warm soapy water and dry them with a
soft cloth.
To remove them follow these
instructions:
• Extract the side grids as indicated in
the previous paragraph.
• Remove both side panels right and left
(fig.9).
1
Remove back panel
respectine locking screws 5 (fig.10).
• Repeat previous operations following
the figures below.
Important! Position both side
panels by taking the locking
1
pin out of the hole
2
.
1
1 .
4 by unscrewing
(fig. 9).
3
fig.8
fig.9
fig.10
ENGLISH 15