Protection Setting Method - Brother S-7000DD Service Manual

2-7. Protection setting method

NOTE: If the slide switch (SW1) on the main P.C. board has been moved to a position other than the middle position, setting
cannot be carried out.
Move the slide switch (SW1) to the middle position (factory default position) and then carry out the following
operations.
(Refer to "3. SLIDE SWITCH (SW1) SETTING METHOD" for details on the slide switch.)
Change to protect setting mode.
1
(While pressing the C
press the power ON switch.)
Set the protection level (1 to 3).
2
[If set to level 1 – 2]
Confirm the protection level (example: set to level 2)
3
(Flashing)
4
key,
Use the D
NOTE:
The range for disabling operation varies depending on the setting position
for SW1.
For details, refer to <Protection setting list> (P.36).
* If the protection level is different from the original value, the protection
level will flash in the display.
Protect setting mode will be exited and normal operation will be possible.
2. FUNCTION SETTINGS (OPERATION PANEL)
• "PLV*" and the protection level will appear in the display.
(* is the protection level. At the time of shipment from the
factory, the protection level is set to "1".)
key to set the protection level (1 to 3).
(Illminated)
S-7000DD
(Protection level)
34