Table of Contents
Advertisement
7
Step
Assemble
Burners,
Check
Ignition
(continued)
Place the burner grates into operating position.
Finalize
Press corner of the grate to the cooktop. The
Installation
grates should be seated and should not rock.
The grill and griddle are secured with screws at
the front. They are designed to be stationary
and should not to be removed.
The griddle has two leveling screws beneath the
rear flue cover which can be used to adjust to
the desired slope. The center screw is for
shipping purposes only and should be removed.
Adjustable low setting
The open top burners and grill valves have an
adjustable low setting. Each valve is individu-
ally tested and adjusted before it is shipped.
Minor adjustments may be required due to
fluctuations in local gas pressure. Adjustments
to increase or decrease gas flow may be
necessary.
• Turn knob counter-clockwise to the LITE
position.
• Once lit, turn the know back to the "LOW"
position.
• Remove the knob.
• Insert a thin-blade flat screwdriver into
the valve shaft. (3/32" blade width
recommended.)
Installation
Professional Gas Cooktops
• Grip the shaft with pliers and turn counter-
clockwise to lower the flame, or clockwise to
increase the flame.
CAUTION: Do not turn the flame so low that
it goes out, causing the igniter to spark.
• When the desired setting is made, replace
the knob and turn burner off.
10
Advertisement
Table of Contents
