Descaling The Nanocloud Rotary Humidification Wick; Replace The Filters; Understanding The Healthy Air Protect Lock; Replacing The Nanoprotect Filter - Philips HU5930 User Manual

Descaling the NanoCloud
rotary humidification wick
Filter alert light status
Cleaning light goes
on (fig. )
1
Pull out the water tank (fig. h).
2
Pull out the water tray (fig. }).
3
Take the wick wheel off the wick support
(fig. ~).
4
Mix the white vinegar with an equal
amount of tap water in a container that
is large enough to soak the NanoCloud
rotary humidification wick in.
Note
•
White vinegar has 5% acetic acid.
•
If there are white deposits (limescale) on
the filter, make sure that the side with the
white deposits is immersed in the water.
•
Do not take the NanoCloud rotary
humidification wick off the wheel during
descaling.
5
Let the NanoCloud rotary humidification
wick soak in the solution for one hour
(fig. „).
6
Rinse the NanoCloud rotary humidification
wick under the tap to rinse away vinegar
residues. During rinsing, turn the wick
so that both front and back are rinsed
(fig. ...).
7
Air dry the NanoCloud rotary
humidification wick.
Note
•
Do not put the NanoCloud rotary
humidification wick under direct sunlight.
8
Touch and hold the reset button
3 seconds to reset the NanoCloud rotary
humidification wick cleaning time (fig. ƒ).
10 EN
Follow this
Descale the
NanoCloud rotary
humidification wick
for
6 Replace the filter
and wick
Understanding the healthy air
protect lock
This appliance is equipped with the healthy
air protect lock to make sure that the Nano
protect filter and the humidification wick are
in optimal condition when the appliance is
operating. When the Nano protect filter and
the humidification wick are almost expired, the
replacement light starts to flash to indicate
that they need to be replaced.
If you do not replace the filter and wick in time,
the appliance will stop operating and get locked.
Replacing the NanoProtect
filter
Note
•
The NanoProtect filter is not washable nor
vacuum cleanable.
Filter alert light status
Filter replacement
light starts flashing
(fig. †)
1
Remove the used NanoProtect filter from
the appliance (fig. ‡).
Note
•
Do not touch the pleated filter surface, or
smell the filter as it has collected pollutants
from the air.
•
Wash your hands after disposing of the used
filters.
Follow this
Replace the
NanoProtect filter