Table of Contents
Advertisement
3815GLA/3895GLA
3815GWLA/3895GWLA
3875GLAC/3875GWLAC
3875GLACR/3875GWLACR
EASY ACCESS
Two Drawer*
VERTICAL GAS
SMOKER
ASSEMBLER / INSTALLER:
Leave these instructions with the consumer.
CONSUMER / USER:
This instruction manual contains important information necessary for the proper assembly
and safe use of this appliance. Read and follow all warnings and instructions before
assembling and using this appliance. Follow all warnings and instructions when using this
appliance. Keep this manual for future reference.
DANGER:
If you smell gas:
1. Shut off gas to the appliance.
2. Extinguish any open flame.
3. Open door.
4. If odor continues, keep away from the
appliance and immediately call your fire
department. If a fire should occur, keep
away from the appliance and call your fire
department. Do not attempt to extinguish
an oil or grease fire with water.
Failure to follow these instruction could result in fire, explosion or burn hazard,
which could cause property damage, personal injury or death.
DANGER:
1. Never operate this appliance unattended.
2. Never operate this appliance within 10
feet (3.05M) of any other gas cylinder.
3. Never operate this appliance within 25
feet (7.5m) of any flammable liquid.
IM381
5/
3895/3875
* Patent Pending
Advertisement
Table of Contents
Related Manuals for Landmann 3875GWLACR
Summary of Contents for Landmann 3875GWLACR
- Page 1 IM381 3895/3875 3815GLA/3895GLA 3815GWLA/3895GWLA 3875GLAC/3875GWLAC 3875GLACR/3875GWLACR EASY ACCESS Two Drawer* VERTICAL GAS SMOKER * Patent Pending ASSEMBLER / INSTALLER: Leave these instructions with the consumer. CONSUMER / USER: This instruction manual contains important information necessary for the proper assembly and safe use of this appliance. Read and follow all warnings and instructions before assembling and using this appliance.
- Page 2 Cartersville, Georgia 30120 Service Note: If you are experiencing difficulties are are dissatisfied with your purchase, please contact Landmann at the telephone number listed above prior to returning your product to the store. For more information about growing family of Smokers,...
- Page 3 DO NOT use this smoker in a manner other than its intended purpose. It is not intended for commercial use. It is NOT intended to be installed or used in or on a recreational vehicle and/or boats. The smoker is not be used as a heater.
- Page 4 WARNING Use caution when operating the door while in operation. Keep hands, face and body safe from hot steam or flare ups. DO NOT wear loose clothing while operating the smoker. Tie back long hair while operating the smoker. ALWAYS wear fully-covering shoes while operating the smoker. Allow the smoker and its components to cool completely before conducting any routine cleaning or maintenance.
- Page 5 Assembly Step 1 - Identifying the parts Check your contents for these parts. If you are missing any parts or if any parts are damaged, please call our toll-free customer service line to order parts: 1-800-321-3473 DO NOT RETURN YOUR SMOKER TO THE RETAILER. PLEASE CALL US FIRST. 3815GLA/3895GLA/3875GLAC/3875GLACR Vertical Gas Smoker AZ002075 AZ001107 Cooking Rack...
- Page 6 1-800-321-3473 DO NOT RETURN YOUR SMOKER TO THE RETAILER. PLEASE CALL US FIRST. 3815GLA/3895GLA/3875GLAC/3875GLACR GAS VERTICAL SMOKER PARTS 3875GLAC/3875GLACR, include cover. 3815GLA/3895GLA, not include cover-available as a purchased accessory via our website: www.landmann-usa.com...
- Page 7 Check your contents for these parts. If you are missing any parts or if any parts are damaged, please call our toll-free customer service line to order parts: 1-800-321-3473 DO NOT RETURN YOUR SMOKER TO THE RETAILER. PLEASE CALL US FIRST. 3815GWLA/3895GWLA/3875GWLAC/3875GWLACR Vertical Gas Smoker AZ002075 AZ002131 AZ001153 Cooking Rack...
- Page 8 1-800-321-3473 DO NOT RETURN YOUR SMOKER TO THE RETAILER. PLEASE CALL US FIRST. 3815GWLA/3895GWLA/3875GWLAC/3875GWLACR GAS VERTICAL SMOKER PARTS 3875GWLAC/3875GWLACR, include cover. 3815GWLA/3895GWLA, not include cover-available as a purchased accessory via our website: www.landmann-usa.com...
- Page 9 Assembly Step 2 Vent Damper Plate with plastic tab guard Phillips Head Screwdriver Hardware Bag #8 Wrench 5.5mm lock washer M5 nut M5x15 bolt 2 required 2 required 2 required 1. Remove all loose inner packages from inside cabinet. Set the cabinet assembly top side down. To prevent scratching or damage to your smoker, set the cabinet on a padded surface like cardboard or carpet.
- Page 10 Assembly Step 3 Cabinet Assembly 4 Legs Phillips Head Screwdriver Hardware Bag M6x15 bolt 8 required 1. For each leg, line up the holes and insert the bolts. Nuts are pre-welded to the cabinet. The back legs bolts should be inserted and securely tightened.
- Page 11 Assembly Step 4 Phillips Head Control Panel Assembly Screwdriver Hardware Bag M6x15 bolt M5x10 bolt 2 remaining bolts from Step 2 2 required 1. Place the control panel assembly between the front legs as shown. Insert the two (2) remaining bolts 1/2 way. DO NOT tighten them until the next step has been finished.
- Page 12 Assembly Step 5 Phillips Head Screwdriver Hardware Bag M6x12 bolt 3 required 1. Set the burner assembly onto the cabinet as shown. IMPORTANT: The burner tube must slide properly onto the brass valve stem as shown below. An improper fit will result in poor gas flow and operation of the smoker. 2.
- Page 13 Assembly Step 6 Meat Hanger Adjustable Chimney Phillips Head Screwdriver Hardware Bag M5x8 bolt M6x10 bolt 1 required 3 required 1. Turn the smoker upright. Ideally, it needs 2 people to lift the smoker up. Carefully tilt the cabinet on the side legs, grasp the empty hole for the adjustable chimney and pull up gently until smoker is upright on all four legs.
- Page 14 Assembly Step 7 Phillips Head Screwdriver 2 Side Carry handles Hardware Bag #10 Wrench M6 nut 6.5mm lock washer M6x15 bolt 8 required 8 required 8 required 1. Align the side carry handle with the corresponding holes on the side of the cabinet.
- Page 15 Assembly Step 8 Water pan drawer Wood chip box drawer Phillips Head with Nylon Plastic handle with Nylon Plastic handle Screwdriver Hardware Bag #10 Wrench M6 nut 6.5mm lock washer M6x12 bolt 4 required 4 required 4 required 1. Align the drawer handle bracket holes to match the holes in the front panel of the drawers. 2.
- Page 16 Assembly Step 9 Grease Wood Chip Box Drawer Cooking racks Water Pan Drawer NOTE: No tools or hardware are required for this step. 1. Insert cooking grids into available rack positions and grease pan as shown. 2. Place lid on the wood chip box and position complete wood chip box on drawer frame as shown. Slide wood chip box drawer into cabinet.
- Page 17 Assembly Step 10 Phillips Head Screwdriver Nylon Plastic Door handle Hardware Bag #10 Wrench M6x12 bolt M6 nut 6.5mm lock washer 2 required 2 required 2 required 1. Align the door handle with the corresponding holes on the front of the cabinet door. 2.
- Page 18 Assembly Step 11 Hardware Box Name-plate Temperature Gauge 2 wingnuts 2 flat washers NOTE: No tools or hardware are required for this step. 1. Insert the Temperture Gauge mounting pins through the mounting holes in the front of the door panel. 2.
- Page 19 Assembly Step 12 Hardware Bag Insert the R-Hook into the pre-threaded mount on the front legs as shown. And firmly tighten it. Using the zip tie, secure the hose to the front leg as shown. Do not pull the zip tie tight - leave it just lose enought so the hose can be adjusted if needed.
-
Page 20: Connecting The Lp Cylinder
CONNECTING THE LP CYLINDER WARNING ALL INSTRUCTIONS AND SAFEGUARDS ON THIS PAGE MUST BE FOLLOWED TO PREVENT FIRE, DAMAGE AND/OR INJURY. IMPORTANT: Any fuel supply cylinder used must be constructed and marked in accordance with specifications for propane cylinders of the U.S. Department of Transportation (DOT) CFR 49, or CAN/CSA B339. - Page 21 CONNECTING THE LP CYLINDER - Continued WARNING ALL INSTRUCTIONS AND SAFEGUARDS ON THIS PAGE MUST BE FOLLOWED TO PREVENT FIRE, DAMAGE AND/OR INJURY. Valve/pressure regulators are factory set to the correct operating pressures. NO attempts should be made to adjust these settings.
-
Page 22: Operating Instructions
OPERATING INSTRUCTIONS PRE-USE PROCEDURES: Before you cook food in our smoker, it is important to “season” your smoker. Seasoning seals the paint and interior of your smoker to enhance flavoring, durability and overall peformance. This is also referred to as the “break-in”... - Page 23 ADDING WOOD CHIPS To add wood chips before smoking, fill the wood chip box with your choice of flavoring hardwood chips. The amount and type of wood you use is entirely up to you. One full filling of the wood chip box is typically enough for several hours of smoking.
-
Page 24: Lighting Procedures
LIGHTING PROCEDURES: Igniter Lighting System: 1. Check all connections for leaks using the “soapy water” test as explained on page 21. 2. Open the smoker cabinet door. 3. Check for any blockage to the venturi tube or burner. Remove any foreign objects or matter. 4. -
Page 25: Cooking Instructions
COOKING INSTRUCTIONS: IMPORTANT: Before each use, clean and inspect the hose and the connection to the LP cylinder. If there is evidence fo abrasion, wear, cuts or leaks, the hose must be replaced before the smoker is used. Refer to the “Leak test instructions” in the LP Cylinder portion on this instruction manual. * Fill the wood chip box with flavoring wood chips and place the box with lid on, inside the smoker as instructed in the assembly section of this instruction manual. -
Page 26: Temperature Chart
TEMPERATURE CHART Here is a chart for measuring properly cooked meat temperature: (USDA Standard) CAUTON The below temperatures are measured with a meat probe thermometer. The heat indicator on the door of the smoker be used as an accurate meat SHOULD NOT temperature reading. -
Page 27: After Use Safety
AFTER USE SAFETY WARNING Use caution when lifting or moving the smoker to avoid strains or back injury. Two (2) people are recommended to lift or move the smoker. DO NOT place cover on smoker if the smoker is still hot. DO NOT store the smoker near gasoline or other combustible liquids or where combustible vapors may be present. - Page 28 AFTER USE CARE AND MAINTENANCE All care and maintenance procedures are to be performed only while the CAUTION: smoker is turned off and completely cooled. To clean, remove the water pan, wood chip box and cooking racks from the smoker. Clean with hot, soapy water and rinse and dry thoroughly.