Zanussi ZDM17301WA User Manual page 13

THE WASHING AND DRYING RESULTS ARE NOT SATISFACTORY
Problem
The dishes are not clean.
Scale particles on the dishes.
There are streaks or milky
stains on glasses and dishes.
There are bluish layers on
glasses and dishes.
The dishes are wet and dull.
ERROR CODES
Code
E1
Possible cause
The selected programme was
not applicable for the type of
load and/or for the degree of
soil.
The basket was not loaded
correctly, water did not reach
all surfaces.
The spray arm could not turn
freely because of the incorrect
arrangement of the load.
The filters are clogged.
The filters are not correctly as-
sembled and installed.
The quantity of detergent was
not enough or no detergent
was used.
The salt container is empty.
The cap of the salt container is
not closed correctly.
The level of the water softener
is too high.
The rinse aid dosage is too
high.
The detergent can be the
cause.
A programme without a drying
phase has been selected.
The rinse aid dispenser is
empty.
Meaning
Longer inlet time.
Possible solution
Make sure that the programme
is applicable for the type of
load and/or for the degree of
soil.
Load the basket correctly.
Make sure that the spray arm
can turn freely before you start
a programme.
Make sure that the filters are
clean.
Make sure that the filters are
correctly assembled and instal-
led.
Make sure that a correct
amount of detergent is used.
Fill the salt container with spe-
cific salt for dishwashers.
Make sure that the salt con-
tainer is correctly closed.
Set the water softener to a
lower level.
Set the rinse aid dispenser to a
lower position.
Try a different brand of deter-
gent.
Set a programme with a drying
phase.
Fill the rinse aid dispenser with
rinse aid.
Possible cause
Tap is not open or water intake
is restricted or water pressure
is too low.
13