Network Settings - Panasonic SC-HC58 Operating Instructions Manual

Network settings

With this feature you can wirelessly stream music from
an iOS device (iPhone, iPod, iPad) or a Mac/PC to this
unit's speakers.
To use this feature (AirPlay), this unit must join the
same 2.4 GHz wireless network as the AirPlay
compatible device (l 22).
≥ It is also possible to use AirPlay without a wireless network
router. (l 11, "Directly streaming to this unit")
Preparation
≥ Place this unit close to the wireless network router.
1
Turn this unit on.
2
Follow the chart below to choose the network
setting method.
Are you using an
iPod touch/iPhone/iPad?
Is the iOS version 5.0 or later?
Yes
l right,
"Method 1"
Does your wireless network router
support WPS?
Yes
l 8,
"Method 2"
≥ To cancel this setting in the middle, press [Í] to turn off the
unit.
*1: Depending on the network environment or the wireless
network router settings, it may take more than 10 mins. to
complete the settings.
No
No / Do not know
l 8,
"Method 3"
Method 1
If you're using an iPod touch/iPhone/iPad.
(iOS version 5.0 or later.)
With this method you will share the wireless network
settings of your iPod touch/iPhone/iPad with this unit.
≥ The following explanations are based on an iPhone.
1
Connect the iPhone to your home wireless
network.
2
Connect the iPhone to this unit.
Choose one of the following connections.
– "IPOD_DOCK" connection compatible iPod touch/
iPhone
– iPod touch/iPhone/iPad with iOS 5.0 or later
iPad
3
Unlock your iPhone and then press and hold
[– NETWORK SETUP] on this unit for more than
3 seconds.
≥ If "NOT SUPPORTED" or "SET WI-FI" is displayed,
check that the iPhone is connected to the wireless
network and try again from step 1.
4
A message will pop-up on your iPhone.
Allow the iPhone to share the wireless network
settings.*
1
{. The Wi-Fi status indicator blinks.
5
The unit's settings are completed when
"SUCCESS" is displayed and the Wi-Fi status
indicator stops blinking and lights in blue.
If "FAIL" is displayed press [OK] and try the setting
again. If "FAIL" is still displayed, try "Method 2" or
"Method 3".
≥ If the iPhone was disconnected midway through, try again
without disconnecting it.
6
Press [OK] on the remote control to exit the
settings.
7
To use AirPlay, turn to page 10.
7
RQT9759