About The Freezer Drawer - GE 20 Owner's Manual And Installation Instructions

About the freezer drawer.

Not all features are on all models.
Appearance and features may vary
Appearance may vary
Appearance may vary
(on some models)
Freezer Shelves and Baskets
A shelf above the ice storage bin
A half-width basket
A deep full-width basket
Basket Removal
To remove the deep full-width basket on
freezer drawer models:
Open the freezer drawer until it stops.
The freezer basket rests on the inside tabs
on the drawer slides.
Lift the basket so that it is out of all 6 slide
bracket tabs.
Tilt the basket and lift out of the drawer.
To remove the half-width basket:
Pull the basket out to the stop location.
Lift the basket up at the front to release it
from the stop hooks on each side.
Lift the basket out to remove it from the
sides.
NOTE: Do not fill baskets higher than the rim of
the basket. This may cause baskets to stick or
jam when opening or closing.
When replacing the deep full-width basket:
Tilt the basket back and lower it down into
the drawer. Rotate the basket to a horizontal
position and press it down into the 6 alignment
tabs.
NOTE: Always be sure that the basket is seated
in all 6 slide bracket tabs before sliding back
into the freezer. The basket can be turned in
either direction front to back and installed into
the freezer.
When replacing the basket, make sure that the
basket goes under the stop hooks on each side.
NOTE: Always be sure to fully close this basket.
GEAppliances.com
9