[Privacy Mask] Page - JVC VN-H557U Instructions Manual

Auto Flip
Auto Flip
Set this item when shooting objects that pass right
under the camera.
The camera stops at the face down position when
vertical rotation is performed, the following
operations are necessary to shoot objects that
pass right under the camera.
A Turn the camera to face down.
B Rotate the camera 180° horizontally.
C Turn the camera to face up.
You can use the [Auto Flip] function to perform the
above operations automatically.
OFF:
0
Auto Flip function does not activate.
Mode1:
0
When the camera faces bottom, it rotates 180°
horizontally and stops. In this case, the
operating direction of the camera is the same as
that of the Pan/Tilt operation.
Mode2:
0
When the camera faces down, it rotates 180°
horizontally and the camera operates in a
direction opposite to that of the Tilt operation.
Select this mode if you wish to operate
continuously. Once operation stops, the
direction will return to normal.
Mode3:
0
When the camera faces bottom, it rotates 180°
horizontally and the operating direction of the
camera is opposite that of the Tilt operation.
However, the operating direction will return to
normal 10 seconds after the operation has
stopped.
[Set values: OFF, Mode1, RMode2, Mode3]
Note :
When [Auto Flip] is set to other than "OFF", the
0
camera can be moved to areas outside the pan
limit with the Tilt operation.
Moving the camera within the pan limit during a
Pan operation stops it at the pan limit position.

[Privacy Mask] Page

Privacy Mask is a feature that enables masking of
a portion of the video image.
You can set 8 rectangular privacy masks for this
unit.
This page can be used during access using
"admin" or "operator".
Click [Advanced Settings] in the side menu, and
0
click [Privacy Mask].
Press the [OK] button to enable the new
0
settings.
If the distribution capability of the camera is
0
exceeded when images are acquired from the
camera by the Built-in Viewer or other clients,
images may not appear on the [Privacy Mask]
page. Stop the Built-in Viewer or other clients
before using the [Privacy Mask] page.
(A p.88 [Exiting Built-in Viewer] )
If the [OK] button is pressed upon entering an
0
invalid value, a warning message will appear
and the entry will be denied. Press the [Cancel]
button to restore the invalid entry to the value
before the change was made.
Note :
When the setting page for privacy mask is
0
opened, zoom will be at the Wide end and [Auto
Flip] is set to "OFF".
To specify the privacy mask settings, set the
0
zoom to the wide-angle end in advance.
The size of the preset mask changes with the
0
pan, tilt, and zoom operation.
The privacy mask settings will also apply to
0
videos recorded to the FTP server or SD card,
as well as those to be distributed.
Settings
* Setting values with R are default values.
[Advanced Settings] Page -[PTZ] Page
51