AEG 37699MO-MN User Manual page 15

Oven seal
The oven seal guarantees the correct
functioning of the oven. We recommend
you:
• clean it, avoiding abrasive tools or
products.
• check its state now and then.
If the oven door seal has become hard
or is damaged, contact our Service
Centre and avoid using the oven until
it has been repaired.
Oven side-guide rails
To allow for a better cleaning of the side
grids, you can extract them this way:
Push with a finger on the last of the slots to
release the grid from its hold.
Lift it towards the top and extract the
grid. To put them back into place, reverse
2
the order of this operation.
fig.8
Self-cleaning panels
Oven walls are protected by panels coated
with a grease-proof, microporous enamel
that absorbs and eliminates splattering
during baking.
If there is a lot of liquid or grease, dry
immediately with a damp sponge and heat
the oven for 2 hours on the maximum
thermostat position. Wait for the oven
to cool down and then go over it again
with a damp sponge. If you are unable
to remove all the substances, repeat the
above procedure.It is, however, advisable
to periodically remove the panels and
wash them with warm soapy water and
dry them with a soft cloth.
To remove them follow these instructions:
• Extract the side grids as indicated in the
• Remove both side panels
• Remove back panel
• Repeat previous operations in reverse
(fig.8)
1
fig.9
fig.10
previous paragraph.
respective locking screws
order to replace all elements.
Important! Position both side panels
by taking the locking pin
1
of the hole (fig. 10).
3
ENGLISH 15
(fig.10).
1
by unscrewing
4
(fig.11).
5
out
2