All rights reserved. No part of this publication may be reproduced, stored in a retrieval system or transmitted, in any form or by any means, electronic, mechanical, photocopying, or otherwise without the prior permission of Philips. Published by EL 0564 TV Service...
EN 2 FTP2.4E AA Technical Specifications, Connections, and Chassis Overview 1. Technical Specifications, Connections, and Chassis Overview Index of this chapter: Connections 1.1 Technical Specifications 1.2 Connections Note: The following connector colour abbreviations are used 1.3 Chassis Overview (acc. to DIN/IEC 757): Bk= Black, Bu= Blue, Gn= Green, Gy= Grey, Rd= Red, Wh= White, and Ye= Yellow.
Page 3
Technical Specifications, Connections, and Chassis Overview FTP2.4E AA EN 3 EXT2: Video RGB/YC - In, CVBS - In/Out, Audio - In/Out DVI-I: Digital/Analogue Video - In C1 C2 C3 C4 E_06532_004.eps 050404 Figure 1-4 DVI-I connector E_06532_001.eps 050404 - D2- - D2+ Figure 1-3 SCART connector - Shield...
Page 4
EN 4 FTP2.4E AA Technical Specifications, Connections, and Chassis Overview Chassis Overview PDP AUDIO PANEL PDP SUPPLY PANEL (ONLY FOR FHP SETS) AMBI LIGHT PANE AMBI LIGHT PANEL SCART 3 PANEL TOP CONTROL PANEL SIDE I/O PANEL SMALL SIGNAL BOARD LED PANEL F_15460_076.eps 130405...
Safety Instructions, Warnings, and Notes FTP2.4E AA EN 5 2. Safety Instructions, Warnings, and Notes Index of this chapter: Service Default Mode (see chapter 5) with a colour bar 2.1 Safety Instructions signal and stereo sound (L: 3 kHz, R: 1 kHz unless stated 2.2 Warnings otherwise) and picture carrier at 475.25 MHz for PAL, or 2.3 Notes...
Lead-free Solder • Use only original spare-parts listed in the Service-Manuals. Not listed standard material (commodities) has to be Philips CE is producing lead-free sets (PBF) from 1.1.2005 purchased at external companies. onwards. • Special information for lead-free BGA ICs: these ICs will be delivered in so-called "dry-packaging"...
Mechanical Instructions FTP2.4E AA EN 7 4. Mechanical Instructions Index of this chapter: Notes: 4.1 Cable Dressing • Figures below can deviate slightly from the actual situation, 4.2 Service Position due to the different set executions. 4.3 Assy/PWB Removal • All photo’s are made of the 42”...
Page 8
EN 8 FTP2.4E AA Mechanical Instructions Assy/PWB Removal 4.3.3 Ambient Light Panel(s) 4.3.1 Metal Back Plate Caution: Disconnect the mains power cord before you remove the metal back plate. F_15460_071.eps 130405 Figure 4-6 Ambient light inverter (left side) F_15460_074.eps 140405 Figure 4-4 Metal back plate 1.
Page 9
Mechanical Instructions FTP2.4E AA EN 9 4.3.6 Audio Panel 4.3.11 SSB F_15460_070.eps F_15460_069.eps 140405 140405 Figure 4-8 Audio panel Figure 4-9 SSB top shielding 1. Disconnect all cables from the Audio panel. 2. Remove all mounting screws (1) from the Audio panel. 3.
Page 10
EN 10 FTP2.4E AA Mechanical Instructions 4.3.12 Ambient Lights E_14650_010.eps 170604 Figure 4-14 Hidden screw F_15460_066.eps 120405 Disassembly 1. Place the TV set face down on the foam bars. Place the Figure 4-12 Ambient light (partly shown) bars at the edges of the TV so they will support the front frame, and not only the glass plate! Ambient lights are located in the rear cover of the TV.
Page 11
Mechanical Instructions FTP2.4E AA EN 11 Set Re-assembly To re-assemble the whole set, execute all processes in reverse order. Note: While re-assembling the TV, make sure that: • All cables are placed and connected in their original position (see figure “Cable dressing”). •...
Service Modes Service Default Mode (SDM) and Service Alignment Mode (SAM) offer several features for the service technician, while the Customer Service Mode (CSM) is used for communication between a Philips Customer Care Centre (P3C) and a SW UPGRADE NORMAL customer.
Page 13
This will give Time 8/30 F1 Broadcaster UTC time from 8/30 Format 1. the Philips Service department an extra possibility for Date 8/30 F1 Broadcaster Date from 8/30 Format 1. diagnosis (e.g. when Development asks for this).
Page 14
EN 14 FTP2.4E AA Service Modes, Error Codes, and Fault Finding to 100 (volume is maximum). Volume values can be Item Source Description changed via the volume key on the RC-transmitter. WSS G3 Broadcaster WSS Group 3 (Subtitles) bits 8 9 10 •...
Page 15
Service Modes, Error Codes, and Fault Finding FTP2.4E AA EN 15 CUSTOMER SERVICE MENU 3 • Options 1. Gives the option codes of option group 1 as set • Balance. Indicates the balance settings, between “-50” in SAM (Service Alignment Mode). and “+50”.
Page 16
Under normal circumstances, a fault in the power supply, or an error during start-up, will switch the television to protection ComPair (Computer Aided Repair) is a service tool for Philips mode. ComPair can take over the initialisation of the television.
Page 17
Service Modes, Error Codes, and Fault Finding FTP2.4E AA EN 17 START Mains cord IN Initialize PDP SDI Max 3.04 sec after 5V and 8V =OK OTC gets supply voltage Set Fixed settings OTC resets, Initialise IO pins PDP ON Reset Audio=high Ebild: POWER ON Read NVM identification...
Page 18
EN 18 FTP2.4E AA Service Modes, Error Codes, and Fault Finding Error Codes • Via ComPair. 5.5.3 How to clear the Error Buffer 5.5.1 Introduction Use one of the following methods: The error code buffer contains all detected errors since the last •...
Page 19
Service Modes, Error Codes, and Fault Finding FTP2.4E AA EN 19 The Blinking LED Procedure from the 3V3 supply, which is derived from the 5V Stand-by- circuitry. Therefore, in both Power-on as in Stand-by mode, the microprocessor is connected to this power supply. 5.6.1 Introduction If a fault situation is detected, an error code will be generated...
Page 20
EN 20 FTP2.4E AA Service Modes, Error Codes, and Fault Finding 5.7.3 OTC Related Protections 2. 25V_HOT_SW (from Preconditioner) present? 3. 17V on pin 15 of item 7001 present? 4. Vcego= “H” and LATCH= “H”? If a protection is detected at an OTC input, the OTC will start to 5.
Page 21
Service Modes, Error Codes, and Fault Finding FTP2.4E AA EN 21 this, the TV goes to protection (I C protection). Error code “55” must desolder all three, otherwise the circuit could be is logged. damaged), connect an external power supply of 3V3 at the For further diagnoses, you need to overrule the I C protection: cathode of diode 6U06.
Page 22
EN 22 FTP2.4E AA Service Modes, Error Codes, and Fault Finding Software Downloading In this chassis, you can upgrade the main software via ComPair without removing the back cover of the TV (it is possible that early production sets don’t have a hole in the back plate, in this case you have to remove the back plate).
Page 78
Circuit Diagrams and PWB Layouts FTP2.4E AA EN 78 Layout SSB (Top Side Overview) Part 1 F_15460_048a.eps Part 2 F_15460_048b.eps Part 3 Part 4 F_15460_048c.eps F_15460_048d.eps F_15460_048.eps 3104 313 6003.7 120405...
Page 80
Circuit Diagrams and PWB Layouts FTP2.4E AA EN 80 Layout SSB (Top Side Part 1) Part 1 F_15460_048a.eps 080405...
Page 81
Circuit Diagrams and PWB Layouts FTP2.4E AA EN 81 Layout SSB (Top Side Part 2) Part 2 F_15460_048b.eps 120405...
Page 82
Circuit Diagrams and PWB Layouts FTP2.4E AA EN 82 Layout SSB (Top Side Part 3) Part 3 F_15460_048c.eps 120405...
Page 83
Circuit Diagrams and PWB Layouts FTP2.4E AA EN 83 Layout SSB (Top Side Part 4) Part 4 F_15460_048d.eps 120405...
Page 84
Circuit Diagrams and PWB Layouts FTP2.4E AA EN 84 Layout SSB (Overview Bottom Side) Part 2 F_15460_049b.eps Part 1 F_15460_049a.eps Part 3 Part 4 F_15460_049c.eps F_15460_049d.eps F_15460_049.eps 3104 313 6003.7 080405...
Alignments FTP2.4E AA EN 101 8. Alignments Index of this chapter: 8.3.1 General 8.1 General Alignment Conditions 8.2 Hardware Alignments For the next alignments, supply the following test signals via a 8.3 Software Alignments video generator to the RF input: 8.4 Option Settings •...
EN 102 FTP2.4E AA Alignments Blend Intensity Table 8-3 White D alignment values Use this alignment when you replace the microcontroller, NVM, or the EBILD. It aligns the level of transparency of the menu- Colour Temp. Cool Normal Warm picture blended into the main-picture. Fixed setting of "16". 0.275 0.286 0.315...
Page 103
Control pheripheral equipment via TV IR receiver (EU only) Tuner type UV1316 / TEDE9 Model with Philips tuner / Alps tuner P50 DVD menu line Yes / No Enable / disable DVD control via user menu with TV RC (EU only)
Page 104
EN 104 FTP2.4E AA Alignments 8.4.4 Opt. No. (Option numbers) Select this sub menu to set all options at once (expressed in two long strings of numbers). Table 8-7 Option number overview (subject to change) Model Number 12 NC Options Group 1 Options Group 2 42PF9966/12 8670 000 20646...
Page 105
Alignments FTP2.4E AA EN 105 Table 8-8 Option overview Byte Bit (dec. value) Subject Options Settings (in decimal values) Remarks 0 (1) Video Repro Feauture Box Type 3= Eagle 1B, 4= Eagle 1C, 5= 1050i/1250i 1 (2) 2 (4) 3 (8) Personal Ambi Light Demo 0= Off, 8= On...
Page 106
EN 106 FTP2.4E AA Alignments Byte Bit (dec. value) Subject Options Settings (in decimal values) Remarks 0 (1) Personal n.a. 1 (2) Auto Store Mode 0= None, 2= PDC/VPS, 4= TXT Page, Fixed to: "None" in the AP-N and US versions. 6= PDC/VPS/TXT Page 2 (4) 3 (8)
Circuit Descriptions, Abbreviation List, and IC Data Sheets FTP2.4E AA EN 107 9. Circuit Descriptions, Abbreviation List, and IC Data Sheets Index of this chapter: Abbreviation List 9.1 Introduction 9.2 Abbreviation List 1080i 1080 visible lines, interlaced 1080p 1080 visible lines, progressive scan Note: 2DNR Spatial (2D) Noise Reduction...
Page 108
Dealer Service Tool: special remote customers wishes control designed for dealers to enter Liquid Crystal Display e.g. service mode LG-Philips LCD Digital Versatile Disc Light Emitting Diode DVI(-d)(-i) Digital Visual Interface (d= digital only) L/L’...
Page 109
Circuit Descriptions, Abbreviation List, and IC Data Sheets FTP2.4E AA EN 109 Red, Green, and Blue colour space; The primary colour signals for TV. By mixing levels of R, G, and B, all colours (Y/C) are reproduced RGBHV Red, Green, Blue, Horizontal sync, and Vertical sync Read Only Memory Service Alignment Mode...