Makita DBN500 Technical Information page 6

R
epair
[4] DISASSEMBLY/ ASSEMBLY
[4]-1. Magazine section (cont.)
DISASSEMBLING
(2) Remove Pusher from Slide door. (Fig. 4)
Fig. 4
1. Pull Pusher toward Set plate installation side fully, and lift up the center hook of Pusher slightly and carefully
without detaching the side hooks of Pusher from Sleeves.
Set plate
Center hook of Pusher
installation
side
Groove end of
Magazine
Note: If the side hooks of Pusher are detached completely
from Sleeves in the grooves of Slide door,
Sleeves and Compression springs 6 will pop out
as drawn right. Therefore, keep the fitting of
Sleeves and the side hooks of pushers by hand.
2. While keep the fitting of Sleeves and the side hooks of Pushers
by hand, release the reaction force of two Compression springs 6
carefully.
3. Stopper, Compression spring 3, Sleeves and Compression springs 6
can be removed from Pusher.
Compression
spring 3
Pusher Sleeve
Side hooks of Pusher
Stopper
Compression spring 6 (2 pcs.)
Pusher Side hooks of Pusher
Slide door
Pusher
Sleeve (2 pcs.)
P 6/ 24
Sleeve (2 pcs.)
Compression spring 6
(2 pcs.)
Compression spring 6 (2 pcs.)