Table of Contents
Advertisement
Cisco WAP361 Features
2
Front Panel
The front panel of the Cisco WAP361 consists of one system LED. For full
descriptions of the colors of the lights and their indications, see
the Hardware
Installation".
Back Panel
RESET—See
"Rebooting the Cisco WAP361 or Resetting to Factory
Defaults"
for information on the RESET button.
PD/LAN0—The Powered Device (PD/LAN0) port is used to power the
Cisco WAP361 using PoE.
Right-Side Panel
The right-side panel of the Cisco WAP361 has a Kensington lock slot. You
can use it to attach a cable and lock to the Cisco WAP361.
48V DC—The 48V DC jack is used to connect the power adapter to the
Cisco WAP361 if you are not using PoE.
Top Panel
The top panel of the Cisco WAP361 has the security screw hole.
Bottom Panel
PSE—The Power Sourcing Equipment (PSE) port is used to power the
device that is connected to the Cisco WAP361 through this port.
LAN1-4—The RJ-45 Ethernet port is an auto-sensing, Gigabit Ethernet
(802.3) port used to connect the Cisco WAP361 to network devices, such
as computers, routers, or switches. We strongly recommend that you use a
Category 5e or better cable for gigabit connectivity.
Default Settings
Parameter
Username
Password
LAN IP Address
Fallback LAN IP
Subnetwork Mask
Cisco WAP361 Quick Start Guide
Default Value
cisco
cisco
DHCP address assigned by server
192.168.1.245
255.255.255.0
"Verifying
3
Hide quick links:
Advertisement
Table of Contents
