Table of Contents
Advertisement
Recording
Scene-to-scene continuity
If the unit is in the rec-pause mode, it is possible to
ensure scene-to-scene continuity with an accuracy of
0 up to 1 frame just by pressing the VTR START
button or lens VTR button.
If the unit is in a mode other than rec-pause, the point
at which the scene-to-scene continuity is to be
maintained must be located before recording is
started.
During rec-pause
The scene-to-scene continuity timing is located
automatically. However, the time taken until the start
of recording differs depending on the setting of the
VTR SAVE/STBY switch.
O When the VTR SAVE/STBY switch is set to SAVE,
recording commences about two seconds after the
VTR START button is pressed.
O When the VTR SAVE/STBY switch is set to STBY,
recording commences as soon as the VTR START
button is pressed.
Ensuring scene-to-scene continuity after
the power was turned off while the unit
was in the rec-pause mode
1
Switch the power back on.
2
Press the VTR START button or lens VTR button
to start the recording.
2
1
67
Ensuring scene-to-scene continuity at
other times
Proceed as follows either after the tape has been
allowed to run or after the cassette has been ejected
or when ensuring continuity on a tape which has been
recorded only in part.
1
While monitoring the viewfinder screen, press the
PLAY/PAUSE button to play back the tape.
2
At the place on the tape where continuity is to be
maintained, press the PLAY/PAUSE (or STOP)
button again to stop the tape.
3
Press the lens RET button. It takes about two
seconds to complete the preparations for the
scene-to-scene continuity.
4
Press the VTR START button or lens VTR button
to start the recording.
1,2
3
4
Advertisement
Table of Contents
