Advertisement
Notes:
- For the fixing of the device basis only use installation material that is suitable for the on-site installation and that ensures a safe and durable fixing.
- When fixing the device basis, attention has to be paid to the marking for the connection of the pipe system (see fig. A).
3. Open the necessary pre-punched cable entries in the device basis (max. 8 x M20 and 6 x M25). If necessary, use a screwdriver.
4. Carefully equip the cable entry/entries with M20 or M25 cable entries (2 x M25, 1 x M20 included in the delivery) by inserting them into the corre-
sponding cable entries.
5. Insert the required connection cable(s) (max. 2,5 mm
described at the following page.
Note:
If the detection unit of Honeywell COMPACT is to be installed at a later stage, the mounted device basis can be protected against excessive con-
tamination by using the bottom of the supplied card box.
In order to use the bottom of the card box as a dust protection, please proceed as follows:
1. Carefully separate the cover along the pre-punched perforation from the bottom of the carton.
2. Open the required openings for the connections of the pipe system, the air return and the cable entries by separating the openings carefully along
the pre-punched perforation from the bottom of the card box.
3. Put the bottom of the card box as protection over the mounted device basis.
Compact unit_HON.doc
2
) into the prepared cable entries and wire the devices according to the circuit connections
07/2011
2/5
Advertisement
