Interlocks And Relays - Husqvarna LTH1797 Owner's Manual

Hide thumbs Also See for LTH1797:

Owner's manual (44 pages)

Operator's manual (68 pages)

Operator's manual (32 pages)

Table Of Contents

Table of Contents

SERVICE AND ADJUSTMENTS

MOTION CONTROL

LEVER

TRANSMISSION REMOVAL/REPLACEMENT

Should your transmission require removal for service or

replacement, it should be purged after reinstallation and

before operating the tractor. See "PURGE TRANS MIS SION"

in the Operation section of this manual.

TO AD JUST STEER ING WHEEL ALIGN MENT

If steering wheel crossbars are not horizontal (left to right)

when wheels are positioned straight forward, remove steer-

ing wheel and reassemble per instructions in the Assembly

section of this manual.

FRONT WHEEL TOE-IN/CAMBER

The front wheel toe-in and camber are not adjustable on

your tractor. If damage has occurred to affect the front

wheel toe-in or camber, contact your nearest authorized

service center/department.

TO REMOVE WHEEL FOR REPAIRS

(See Fig. 22)

•

Block up axle securely.

•

Remove axle cover, retaining ring and washers to allow

wheel removal (rear wheel contains a square key - Do

not lose).

•

Repair tire and reassemble.

•

On rear wheels only: align grooves in rear wheel hub

and axle. Insert square key.

•

Replace washers and snap retaining ring securely in

axle groove.

•

Replace axle cover.

NOTE: To seal tire punctures and prevent flat tires due to

slow leaks, tire sealant may be purchased from your local

parts dealer. Tire sealant also prevents tire dry rot and

corrosion.

WASH ERS

RE TAIN ING

RING

AXLE COVER

SQUARE KEY (REAR

WHEEL ONLY)

NEUTRAL

LOCK

GATE

ADJUSTMENT

BOLT

FIG. 21

FIG. 22

TO START ENGINE WITH A WEAK BATTERY

(See Fig. 23)

WARNING: Lead-acid batteries gen er ate ex-

plo sive gases. Keep sparks, flame and smok-

ing ma te ri als away from bat ter ies. Always

wear eye pro tec tion when around batteries.

If your battery is too weak to start the engine, it should be

recharged. (See "BATTERY" in the Maintenance sec tion

of this manual.)

If "jumper cables" are used for emergency starting, follow

this procedure:

IMPORTANT: YOUR TRACTOR IS EQUIPPED WITH A

12 VOLT SYSTEM. THE OTHER VEHICLE MUST ALSO

BE A 12 VOLT SYSTEM. DO NOT USE YOUR TRACTOR

BATTERY TO START OTHER VEHICLES.

TO ATTACH JUMPER CABLES -

•

Connect one end of the RED cable to the POSITIVE

(+) terminal of each battery (A-B), taking care not to

short against tractor chassis.

•

Connect one end of the BLACK ca ble to the NEGA TIVE

(-) terminal (C) of fully charged battery.

•

Connect the other end of the BLACK cable (D) to good

chassis ground, away from fuel tank and bat tery.

TO REMOVE CABLES, REVERSE ORDER -

•

BLACK cable first from chassis and then from the fully

charged battery.

•

RED cable last from both batteries.

WEAK OR

DEAD BATTERY

TO REPLACE HEADLIGHT BULB

•

Raise hood.

•

Pull bulb holder out of the hole in the backside of the

grill.

•

Replace bulb in holder and push bulb holder securely

back into the hole in the backside of the grill.

•

Close hood.