Installation Of The Charging Station - Husqvarna 265 ACX Operator's Manual

1157068-26,265ACX_GB.book Page 19 Friday, November 28, 2014 9:06 AM
• Screws for the charging station (24)
• Measurement gauge (25)
• Connector for the loop wire (23)
• Solderless coupler for the loop wire (26)
Contact your dealer to purchase the following
installation material:
• Loop wire for the boundary wire and guide wire
(19)
• Staples (22)
During installation you will also need:
• Hammer/plastic mallet to simplify putting the
staples in the ground.
• Combination pliers for cutting the boundary
wire and pressing the contact units together.
• Polygrip (for pressing the couplers together).
• Edge cutter/straight spade if the boundary wire
must be buried.
3.2 Installation of the charging
station
Best charging station location
Take the following aspects into consideration when
identifying the best location for the charging station:
• Allow for 3 metres of free space in front of the
charging station
• Close to a wall socket. The supplied low voltage
cable is 20 metres long.
• A level surface to place the charging station on.
• Protection from water spray for instance from
irrigation
• Protection from direct sunlight
• Place in the lower part of a working area that
has a major slope
• Possible requirement to keep the charging
station out of sight for outsiders
• Any aesthetic preferences
For examples of where best to install the charging
station, see 7. Garden example on page 64.
If you are going to install a guide wire, read 3.8
Installation of the guide wire, see page 35, before
choosing the position of the charging station.
3. INSTALLATION
3018-057
English - 19