Makita BO6050 Instruction Manual page 7

1. Abrasive disc
To install the abrasive disc or the hook-and-loop type
pad (optional accessory), first remove all dirt and for-
eign matter from the pad.
Then attach the abrasive disc to the pad, using the
hook-and-loop system of the abrasive disc and the pad.
Be careful to align the holes in the abrasive disc with
those in the pad.
To remove the disc from the pad, just pull up from its
edge.
Changing pad
CAUTION:
Make sure the new pad is installed
securely. Otherwise the pad may come off from the
tool and cause personal injury.
2
1. Random orbit with forced rotation mode
lock button 3. Pad
Makita offers an extensive range of optional super soft,
soft and hard pads.
To change the pad, perform as follows:
1. Use the change knob and change the mode into
random orbit with forced rotation mode.
2. Press and hold the shaft lock button, and remove
the pad by turning the pad counterclockwise.
3. Keep holding the shaft lock button, and install a
new pad by turning the pad clockwise firmly.
Dust nozzle
CAUTION:
Make sure the bolt is securely
tightened after installing the dust nozzle.
Otherwise the dust nozzle may fall and cause per-
sonal injury.
1
1
3
2. Shaft
NOTICE:
Do not carry the tool by the dust noz-
zle. Otherwise the tool may be damaged.
You can remove the dust nozzle in accordance with the
operation.
To remove the dust nozzle, loosen the bolt, slightly open
the holder part, and remove the dust nozzle.
To install the dust nozzle, insert the mouth of the dust
nozzle into the dust outlet of the housing, align the
tongue of the holder part with the groove of the housing,
and tighten the bolt.
2
3
1
1. Dust nozzle 2. Dust outlet
1. Holder part 2. Bolt
Dust collection (optional accessory)
3
1. Front cuffs 24 2. Hose
If a Makita hose is used, you can connect the front cuffs
24 to the dust outlet directly.
3. Mouth
2
1
1
2
3. Dust outlet
ENGLISH 7