Before Operating; To Set The Clock; Timer; Stop/Clear - Bosch HMD8053UC Use And Care Manual

Before Operating

Before operating your new Drawer Microwave make
sure you read and understand this operation manual
completely.
• Before the Drawer Microwave can be used, follow these
steps:
Plug in the Drawer Microwave.
1.
WAVE TOUCH CLEAR
appear.
Touch the Stop/Clear pad.
2.
Set clock.
3.

To Set the Clock

Touch Timer/Clock pad and number
1.
Touch number pads for correct time of day and touch
2.
Timer/Clock pad again.
This is a 12 hour clock. If you attempt to enter an incorrect
clock time, will appear in the display. Touch the
ERROR
Stop/Clear pad and re-enter the time.
• If the electrical power supply to your Drawer Microwave
should be interrupted, the display will intermittently
show
ENJOY YOUR
AND TOUCH CLOCK
this occurs during cooking, the program will be erased.
The time of day will also be erased. Simply touch
Stop/Clear pad and reset the clock for the correct time
of day.
Note:
• The Drawer Microwave can be programmed with the
drawer open except for Start (+1 min)

Timer

1. Touch Timer/Clock pad and number
2. Enter time.
3. Touch Timer/Clock pad again.
To cancel timer, touch Stop/Clear.
English 9
ENJOY YOUR
AND TOUCH CLOCK
will appear.
:
.
2
MICRO-
WAVE TOUCH CLEAR
after the power is reinstated. If
.
1

Stop/Clear

Touch the Stop/Clear pad to:
• Erase if you make a mistake during programming.
• Cancel timer.
• Stop the Drawer Microwave temporarily during timed
MICRO-
cooking.
will
• Return the time of day to the display.
• Cancel a program during cooking; touch twice for timed
cooking.

Open or Close Drawer Microwave

Always press the Open or Close key on the control panel
to open or close the drawer.
Do not push or pull the drawer by hand, except in case of
emergency, such as during a power failure. If necessary,
push or pull slowly.
Note:
If the unit is flush-mounted with no power, open the unit by
using the following procedure:
Using needle nosed pliers, grab one of the inside columns
at the bottom vent of the door (careful not to scratch or
damage the plastic/decoration) and pull door open. A 90
degree angled screwdriver and/or angled hex key may
also be used by inserting into the middle of the bottom
door vent to catch the bottom of the plastic door frame
and carefully pull open (see below).
Use needle nose
pliers to grab plastic
vent column.
Use 90 degree angled
screw driver or an angled
hex key and insert through
vent opening to pull open.