User Guide
Remove the two keypad screws and slide the keypad down and lift.
4.
Lift the SD card retaining door.
5.
Position the SD card, with the contacts down, into the SD card holder. The SD card corner notch fits into the
6.
holder only one way.
Snap the retaining door closed.
7.
SD Card Retaining Door
Figure 10 Inserting the SD Card
Replace the keypad and re-attach using the two screws.
8.
Perform a warm boot.
9.
CAUTION Do not apply more than 0.452 nm or 4 in-lbs of torque when tightening the keypad screws.
Connection to the PC
The MC9190-NI series is delivered with a Microsoft WM 6.5 operating system or follow-up version. Microsoft
supplies software free of charge to establish a connection to a PC for synchronisation, installation and data
exchange.
SD Card
33