Basic Waypoint Selection - Honda ARX1200T3DXT3 Owner's Manual

There are two methods for marking
waypoints.
• Basic (to select your current position)
• Advanced (to input desired destinations)

Basic Waypoint Selection

To Mark Your Present Position:
1. You may mark your position with the
engine ON – or with the engine off and the
safety lanyard lock clip inserted in the
engine stop button/switch. If you turn the
engine off, wait about 30 seconds for the
display to clear.
2. Use the mode select button to select the
GPS mode.
3. To select a higher waypoint number (1),
press and release the plus button (2).
To select a lower waypoint number, press
and release the minus button (3).
To fast scroll, press and hold the plus or
minus button until the desired waypoint
number appears.
4. Press and hold the WP SET button (4) for
about 2 seconds, until the waypoint
number flashes. Then release the button.
(2)
(3)
(4)
(1) waypoint number (3) minus button
(2) plus button (4) WP SET button
GPS Mode
(1)
(cont'd)
77
GPScape System