Residual Risks; Assembly And Adjustments - DeWalt DWDO14S-XE Instruction Manual

Residual Risks

T he following risks are inherent to the use of drills:
– Injuries caused by touching the rotating parts or hot parts of the tool.
In spite of the application of the relevant safety regulations and the implementation of
safety devices, certain residual risks cannot be avoided. These are:
– Impairment of hearing .
– Risk of squeezing fingers when changing accessories.
– Health hazards caused by breathing dust developed when working in wood.
– Risk of personal injury due to flying particles.
– Risk of personal injury due to prolonged use.
SAVE THESE INSTRUCTIONS FOR FUTURE USE
Motor
Your D WALT tool is powered by a D WALT-built motor. Be sure your power supply
E E
agrees with the nameplate markings. Voltage decrease of more than 10% will cause
loss of power and overheating. All D WALT tools are factory tested.
E
FIG. 1
D
A
C
SHOWN IN
FORWARD
POSITION
A
G
B
E
F
COMPONENTS (Fig. 1)
WARNING: Never modify the power tool or any part of it. Damage or personal
injury could result.
A. Variable speed trigger switch
B. Lock-on button
C. Forward/reverse lever
D. Chuck
INTENDED USE
These variable speed reversible drills are designed for professional drilling.
DO NOT use under wet conditions or in presence of flammable liquids or gases.
These drills are professional power tools.
DO NOT let children come into contact with the tool. Supervision is required when
inexperienced operators use this tool.

ASSEMBLY AND ADJUSTMENTS

WARNING: To reduce the risk of injury, turn unit off and disconnect tool from
power source before installing and removing accessories, before adjusting or
changing set-ups or when making repairs. Be sure the trigger switch is in the OFF
position. An accidental start-up can cause injury.
Forward/Reverse Lever (fig. 1)
The forward/reverse lever (C) is used for withdrawing bits from tight holes and
removing screws. It is located above the trigger switch.
To reverse the motor, release the trigger switch FIRST and then push the lever to the
right (viewed when holding the drill in the operating position).
After any reversing operations, return lever to forward position.
Keyless Chuck (fig. 1, 2–4)
The DWD014S-XE feature a keyless chuck (D) for greater convenience.
TO INSERT A DRILL BIT OR OTHER ACCESSORY
1. Grasp the rear half of the chuck with one hand and use your other hand to rotate
the front half counterclockwise, as shown in Figure 2. Rotate far enough so that
the chuck opens sufficiently to accept the desired accessory.
4
E. Cord protector with key holder
F. Cord set
G. Main handle