Changing The Rubber Flap; Pulley Removal - Toro 07050 Operator's Manual

66in rake-o-vac

Hide thumbs Also See for 07050:

Table of Contents

Changing the Rubber

Flap

Replace the rubber flap when it becomes worn or

damaged.

CAUTION

Change rubber flap on a flat, level surface and block

wheels to prevent sweeper from rolling. Failure to

do so may result in personal injury.

1. Remove the 10 bolts, washers, and nuts on the

mounting flap and flap retainer (Figure 29).

Figure 29

1. Rubber flap

2. Replace with the new rubber flap and fasten it

securely.

g015275

2. Flap retainer

1. Remove the bolts and lockwashers one at a time and

screw them into the adjoining holes (Figure 30).

1. Bolts & locknuts

2. Taper lock bushing

2. Turn each bolt the same number of times until the

lock separates. The pulley will now slide off of the

shaft.

Figure 30

3. Taper lock release hole

g015283

Table of Contents