Configuration Procedure - HP 5920 series Configuration Manual

Figure 23 Network diagram
PIM network

Configuration procedure

Assign the IP address and subnet mask to each interface as shown in
1.
shown.)
Configure OSPF on the PIM network to make sure the network-layer is interoperable on the PIM
2.
network and the routing information among the switches can be dynamically updated. (Details not
shown.)
Enable IP multicast routing, and enable IGMP and PIM-DM:
3.
# On Switch A, enable IP multicast routing globally, enable IGMP on VLAN-interface 100, and
enable PIM-DM on each interface.
<SwitchA> system-view
[SwitchA] multicast routing-enable
[SwitchA] interface vlan-interface 100
[SwitchA-Vlan-interface100] igmp enable
[SwitchA-Vlan-interface100] pim dm
[SwitchA-Vlan-interface100] quit
[SwitchA] interface vlan-interface 101
[SwitchA-Vlan-interface101] pim dm
[SwitchA-Vlan-interface101] quit
# On Switch B, enable IP multicast routing globally, enable IGMP on VLAN-interface 200, and
enable PIM-DM on each interface.
<SwitchB> system-view
[SwitchB] multicast routing-enable
[SwitchB] interface vlan-interface 200
[SwitchB-Vlan-interface200] igmp enable
[SwitchB-Vlan-interface200] pim dm
[SwitchB-Vlan-interface200] quit
Vlan-int100
10.110.1.1/24
Switch A
Querier
Vlan-int200
10.110.2.1/24
Switch B
Vlan-int200
10.110.2.2/24
Switch C
Receiver
Host A
N1
Host B
Receiver
Host C
N2
Host D
57
Figure 23. (Details not