Removing The Carburetor Heater Box; Installing The Carburetor Heater Box; Filling The Fuel Tank - Toro 38606 Operator's Manual

Removing the Carburetor
Heater Box
If you operate the engine when the air temperature is
above 40°F (4°C), remove the carburetor heater box
(Figure 18).
1. Muffler guard
2. Spark-plug wire
1. Disconnect the wire from the spark plug and ensure
that the wire does not contact the plug (Figure 18).
2. Remove the key from the ignition switch (Figure 14).
3. Pull the choke knob off (Figure 14).
4. Remove the fasteners that secure the carburetor
heater box in place (Figure 18).
Note: Install these fasteners in their holes for safe
keeping.
5. Lift the carburetor heater box up and away from
the engine.
6. Disconnect the green ground wire clip under the
throttle (Figure 19).
Figure 17
Figure 18
3. Screws
4. Carburetor heater box
1. Green ground wire clip
7. Install the choke knob.
8. Insert the ignition key.
9. Connect the wire to the spark plug.
Important: Use the carburetor heater box as a
reference for the choke and throttle positions.
Installing the Carburetor
Heater Box
To install the carburetor heater box, reverse the steps
given in Removing the Carburetor Heater Box. Remove
the fasteners from their holes before installing the
carburetor heater box.

Filling the Fuel Tank

Gasoline is extremely flammable and explosive.
A fire or explosion from gasoline can burn you
and others.
• To prevent a static charge from igniting
the gasoline, place the container and/or
snowthrower on the ground before filling,
not in a vehicle or on an object.
• Fill the tank outdoors when the engine is
cold. Wipe up spills.
• Do not handle gasoline when smoking or
around an open flame or sparks.
• Store gasoline in an approved fuel container,
out of the reach of children.
Fill the fuel tank with fresh unleaded regular gasoline
from a major name-brand service station.
13
Figure 19