Installation; Location; Climate Range; Ventilation - Miele K 34472 iD Operating And Installation Instructions

Installation

This appliance must be built in, oth-
erwise it could tip up.

Location

This appliance should not be installed
where it is exposed to direct sunlight or
directly adjacent to a heat-producing
appliance such as an oven or a radiator.
The higher the ambient temperature of
the room, the more energy the appli-
ance requires to operate. The appliance
should be installed in a dry, well ventil-
ated room.
When installing the appliance, please
note:
– The socket must be easily accessible
in an emergency, not concealed be-
hind the appliance.
– The plug and cable must not touch
the rear of the appliance as they
could be damaged by vibrations from
the appliance.
– Do not plug in other appliances be-
hind this appliance.

In environments with high hu-
midity condensation can build up on
the external appliance panels.
This can lead to corrosion of the
panels.
For prevention, it is advisable to in-
stall the appliance with sufficient
ventilation in a dry and/or air condi-
tioned room.
Make sure that the appliance door
closes properly, the ventilation gaps
are not covered and the appliance is
installed in accordance with these in-
stallation instructions.
60

Climate range

The appliance is designed for use within
a certain climate range (ambient tem-
peratures) and should not be used out-
side this range. The climate range of the
appliance is stated on the data plate in-
side the appliance.
Climate range
SN
N
ST
T
Operating in a room which is too cold
will cause the compressor to switch off
for too long, causing the internal tem-
perature in the appliance to rise with the
risk of food deteriorating and going off.

Ventilation


If the ventilation gaps given are
not observed, the compressor will
run more frequently and for longer
periods.
This will result in increased energy
consumption and a higher operating
temperature for the compressor. This
may, in turn, cause damage to the
compressor.
It is essential to observe the ventila-
tion gaps given.
Air at the back of the appliance gets
warm. The appliance housing unit must
therefore be constructed to allow suffi-
cient space for ventilation (see "Build-
ing-in dimensions"):
Ambient room
temperature
+10 to +32 °C
+16 to +32 °C
+16 to +38 °C
+16 to +43 °C