4.4
Advanced System Configuration
The Advanced System Configuration section has a three-page screen
display. The first two pages of this section are accessible with m as well as
the no-reboot Setup button (
no-reboot Setup button. The following is page 1.
Power Management Mode ---------------------- [Enabled]
Display Standby Timer ------------------- [ 1] Minute(s)
Hard Disk Standby Timer ----------------- [ 1] Minute(s)
System Standby/Suspend Timer ------------ [ 3] Minute(s)
Battery-low Warning Beep ------------------- [Enabled]
Suspend upon Battery-low ------------------- [Enabled]
Password Check during Resume --------------- [Disabled]
= Move Hightlight Bar,
PgDn/PgUp = Move Screen, F1 = Help, Esc = Exit
4.4.1
Power Management Mode
With this parameter set to
unless specifically disabled by the user. Select
the timers.
If APM is installed under DOS or Windows, you cannot disable
the Power Management Mode under Setup. To disable APM,
type Power Off under DOS, or disable the Power icon in the
Windows Control Panel.
Setup
). The third page is accessible only with the
Advanced System Configuration
= Change Setting
[Enabled]
, all the timers in Setup take effect
[Disabled]
Page 1/3
to turn off all
4-7