Table Of Contents; Introduction - Toro 03863 Reelmaster 6500 Operator's Manual

Introduction

Read this information carefully to learn how to operate
and maintain your product properly and to avoid injury
and product damage. You are responsible for operating
the product properly and safely.
You may contact Toro directly at www.Toro.com for
product and accessory information, help finding a
dealer, or to register your product.
Whenever you need service, genuine Toro parts, or
additional information, contact an Authorized Service
Dealer or Toro Customer Service and have the model
and serial numbers of your product ready. Figure 1
identifies the location of the model and serial numbers
on the product. Write the numbers in the space
provided.
1. Location of the model and serial numbers
Model No.
Serial No.
This manual identifies potential hazards and has
safety messages identified by the safety alert symbol
(Figure 2), which signals a hazard that may cause serious
injury or death if you do not follow the recommended
precautions.
© 2008-The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Figure 1
1. Safety alert symbol
This manual uses 2 other words to highlight information.
Important calls attention to special mechanical
information and Note emphasizes general information
worthy of special attention.
Contents
Introduction................................................................. 2
Safety ........................................................................... 3
Safety and Instructional Decals ............................. 3
Setup............................................................................ 4
1 Inspection ......................................................... 5
2 Removing the Tipper Assemblies ....................... 5
3 Mount the Lift Brackets and Chains.................... 5
4 Cutting Unit Kickstand ...................................... 6
5 Adjusting the Rear Shield ................................... 7
6 Mount the Counter Weights ............................... 7
7 Installing the Cutting Units ................................ 8
Product Overview ...................................................... 10
Specifications ..................................................... 10
Cutting Unit Accessories and Kits (see parts
catalog for part numbers)................................ 11
Operation................................................................... 12
Adjustments....................................................... 12
Height of Cut Chart Terms ................................. 13
Height of Cut Chart............................................ 14
Servicing Bedknife ............................................. 16
Maintenance............................................................... 18
Lubrication......................................................... 18
Adjusting the Reel Bearings ................................ 18
Servicing the Bedbar........................................... 19
Servicing the Roller ............................................ 20
2
Figure 2
Contact us at www.Toro.com.
Printed in the USA.
All Rights Reserved