Cleaning; Removing Of The Machine Hoods; Checking And Adjusting The Steering Wires - Husqvarna 111B Operator's Manual

Cleaning

Clean the machine directly after use. It is much easier to wash
off grass cuttings before they dry.
Oily dirt can be removed using a cold degreasing agent.
Spray on a thin layer.
Rinse at normal water pressure.
Do not direct the jet towards electrical components or
bearings.
Do not rinse hot surfaces such as the engine and exhaust
system.
Hose down the cutting unit with water underneath each
time it is used.
It is recommended that you start the engine and run the
mower for a short period after cleaning, so that any remaining
water is blown off.
Lubricate the machine if necessary after cleaning. Carry out
extra lubrication when the bearings have been exposed to a
degreaser or a water jet.
IMPORTANT! Avoid using a high pressure washer or a IMPORTANT! Avoid using a high pressure washer or a IMPORTANT! Avoid using a high pressure washer or a
steam cleaner.
There is a major risk of water penetrating into bearings and There is a major risk of water penetrating into bearings and There is a major risk of water penetrating into bearings and
electrical connections. Corrosion attack can result, which will
lead to running problems. Cleaning additives generally lead to running problems. Cleaning additives generally lead to running problems. Cleaning additives generally
aggravate the damage.

Removing of the machine hoods

ving of the machine hoods ving of the machine hoods
Engine cover
The engine becomes accessible for service when the engine
cover is opened.
Loosen the snap locks (one on each side) and fold the cover
backwards.
Maintenance
k can result, which will k can result, which will
Front cover
Release the clip on the front hood and lift off the fender.
Right-hand fender
Loosen the screws holding the wing cover. On Rider 111B,
the knob for the back pedal should also be removed.
Left-hand fender Left-hand fender Left-hand Left-hand f Left-hand fender Left-hand f Left-hand f fender ender
Loosen the Loosen the scre Loosen the screws holding the wing cover and lift off the screws holding the wing cover and lift off the ws holding the wing cover and lift off the
cover. cover. cover.
Checking and adjusting the steering
wires
The steering is controlled by means of wires. These can in
time become slack, which implies that the adjustment of the
steering becomes altered.
Check and adjust the steering as follows:
1 Remove the frame plate by loosening the screws. 3
screws at the front and 2 under the seat.
– 17
English