Fujitsu PRIMERGY BX600 User Manual page 162

Update revision 08.2004
Modified troubleshooting and tips
System will not boot after installing a new hard disk drive
Incorrect SCSI configuration (onboard SCSI HostRAID controller)
Ê In the SCSI configuration menu, check the settings for the hard disk
drives (SCSI Device Configuration) and the settings under Advanced
Configuration Options.
Drives are reported as "dead" at system boot
Configuration of the RAID controllers is wrong
Ê Check and correct the settings for the drives with the RAID controller
utility.
Further information can be found in the operating manual for the RAID controller
(for more information on the HostRAID functionality of the onboard SCSI
controller, see the ServerBooks CD under "Controllers").
Added drive is reported defective
RAID controller is not configured for the drive
The drive was probably installed with the system switched off.
Ê Reconfigure the RAID controller for the hard disk drive using the RAID
controller utility. Further information can be found in the operating manual
for the RAID controller (for more information on the HostRAID function-
ality of the onboard SCSI controller, see the ServerBooks CD under
"Controllers").
or
Ê Re-install the drive while the system is switched on.
If the hard disk drive is still reported defective, then replace it.
02 BX600 162
– –
March 2006
Updates
U41057-J21-Z146-1-76