1090 Sub Board - Lenovo TAB 2 A10-30 Hardware Maintenance Manual

Lenovo TAB 2 A10-30 Hardware Maintenance Manual

1090 Sub board

For access, detach the following FPCs and wire connections:
• Rear cover assembly (see Step 1 on page 35 to Step 2 on page 35 in "1010 Rear
• Battery FPC (see Step 1 on page 37 to Step 3 on page 38 in "1020 Battery
• Vibrator motor wire connections (see Step 1 on page 44 in "1050 Vibrator
1. Remove the mylar on the main FPC at the sub board side as shown in the
58
Important notices for handling PCB:
When handling PCB, bear the following in mind:
• Be careful not to drop the PCB onto a bench top that has a hard surface,
such as surface made of metal, wood, or composite materials.
• Avoid rough handling of any kind.
• Make sure not to drop or stack the PCB in the whole process.
• Make sure to put the PCB only on surface covered with such materials as
an ESD mat or conductive corrugated plate.
cover and side key")
pack")
motor")
figure below.
Figure 9-1. Removing the mylar on the main FPC (sub board side)