Setting Warmer Drawer Controls - Kenmore 790.7185 Series Use And Care Manual

Setting Warmer Drawer Controls

Warmer (Warm & Ready™) Drawer Indicator Light (some models)
The indicator light is located above the warmer drawer thermostat control. It turns on when the control is set, and stays
on until the control is turned off. The warmer drawer is inoperable during the self-clean cycle. The indicator light will not
come on during the self-clean cycle.
To Remove and Replace Warmer (Warm & Ready™) Drawer (some models)
Figure 1
Figure 2
To Remove Warmer Drawer:
1. Turn power off before removing the warmer drawer.
2. Open the drawer to the fully opened position.
3. Locate glide lever on each side of drawer, pull up on the left glide lever
and push down on the right glide lever (see figure 1).
5. Pull the drawer away from the range.
To Replace Warmer (Warm & Ready™) Drawer:
1. Pull the bearing glides to the front of the chassis glide (see figure 2).
2. Align the glide on each side of the drawer with the glide slots on the
range.
3. Push the drawer into the range until levers "click" (approximately 2").
Pull the drawer open again to seat bearing glides into position. If you do
not hear the levers "click" or the bearing glides do not feel seated
remove the drawer and repeat steps 1 thru 3. This will minimize
possible damage to the bearing glides.
NOTE: The Warmer Drawer will NOT operate while in the Self-Clean and "Oven
Lockout" modes
serious injury or death. Disconnect appliance from electric
power before cleaning and servicing the warmer drawer.
15
Electrical Shock Hazard can occur and result in