Page 2
The integrated amplifier in the VCTBS10 features both high pass and low pass crossovers, and a control for adjusting the input sensitivity from 0.2V to 3V .
Page 3
If your head unit does not have RCA outputs , you can use the speaker outputs. If the RCA outputs are not present, connect the speaker outputs from outputs for the audio source for the VCTBS10. Use the supplied cable the receiver to the high level input connector of the amplifier. Be sure to and connect the outputs properly as shown in the connection diagram observe polarity to avoid audio phase problems.
Page 4
• Check all power, remote on and ground Connedions • connections VCTBS10 Owner's Manual-6...